【摘 要】
：
Jets of non-Newtonian liquids are present in many technical applications from agriculture over food processing to medical applications.We use our in-house m
【机 构】
：
Institute of Aerospace Thermodynamics(ITLR)University of Stuttgart,Germany
【出 处】
：
13th International Conference on Liquid Atomization and Spra
论文部分内容阅读
Jets of non-Newtonian liquids are present in many technical applications from agriculture over food processing to medical applications.We use our in-house multiphase Computational Fluid Dynamics code Free Surface 3D(FS3D)to perform incompressible direct numerical simulations of non-Newtonian liquid jets injected into air in the near nozzle region.FS3D uses the Volume of Fluid(VOF)method for interface tracking in combination with piecewise linear interface calculation(PLIC)to reconstruct the liquid interface.Different aqueous solutions of the polyacrylamide polymer Praestol are used as the injected shear-thinning fluids.The material properties are calculated from the Carreau-Yasuda model which is fitted to experimental data.We simulate different parameters which influence the stability of the jet such as the Reynolds number,the velocity profile of the injection representing different nozzle characteristics,ambient pressure,and the shear thinning behavior of the liquid by varying the concentration of Praestol in the solution.We calculate the expansion of the jet and the increase in surface area from the simulation data and we analyze the viscosity inside the liquid jet.Furthermore a quantitative analysis of the wave structures forming on the jet surface is performed in order to evaluate the influence of the different parameters.By this analysis we make a step towards predicting the droplet size distributions resulting from jet breakup,thus providing a way to increase the efficiency of the above mentioned processes.
其他文献
Data pertaining to the burning rate of an isolated liquid fuel droplet in a turbulent flow field is scarce.In the present study,an investigation of the effe
The fuel-water internally rapid mixing type of injector has been developed to reduce NOx and soot emissions from combustion furnaces operating under high-lo
Surfactant is commonly added to ink or paint as dispersive agents for pigment or dye.The surfactant also interferes with the atomization of the liquid sheet
Two-phase flashing spray holds a special interest in the safety area.High pressure liquids or liquefied gases accidentally released from small hole in chemi
Butanol,in comparison with ethanol,has more similar properties of current transportation fuel.These means it has a potential of being a more suitable blend
The generation of bubbles caused by inserting a gas stream into a liquid is a common area of research because it occurs in many technical applications for e
The interaction of two burning drops along the stream direction was studied experimentally using a freefalling drop apparatus which provided different initi
The fuel economy and power output have been advanced significantly by the application of the direct injection spark ignition technique in gasoline engines.A
Ethanol and ethanol-gasoline mixtures exhibit specific physical and chemical properties that govern the processes chain of atomization,evaporation,mixing,co
The presence of cavitation and turbulence in a diesel injector nozzle has significant effects on the subsequent spray characteristics.In this paper,the infl