气体加湿度对质子交换膜燃料电池起动电流的影响实验研究

来源 :第十五届全国氢能会议暨第7届两岸三地氢能研讨会 | 被引量 : 0次 | 上传用户：ryanme

【摘要】

：

质子交换膜燃料电池在实际应用中不可避免会经历起动、加减速和停机等动态工况.其中在起动过程中,气体加湿度不仅影响电池输出,还影响电池寿命.目前有关加湿度对电池起动的影响研究较少,尤其是耦合了温度,负载等操作工况加湿度对起动电流的实验研究很少.本文研究了不同温度,负载,气体流量和起动初始条件下气体加湿度对起动电流的影响,并采用电流分布测量垫片测量了相应工况条件下局部起动电流,探讨了起动时电池内部的传质

【作者】

：

刘风风贾斐刘洪潭郭烈锦

【机构】

：

动力工程多相流国家重点实验室,西安交通大学,西安,710049 动力工程多相流国家重点实验室,西安

【出处】

：

第十五届全国氢能会议暨第7届两岸三地氢能研讨会

【发表日期】

：

2014年7期

下载到本地 , 更方便阅读

下载此文赞助VIP

声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架

论文部分内容阅读

其他文献

储氢罐快速充气模拟的集总参数模型与CFD模型的比较

储氢罐快速充气对于氢燃料电池电动汽车的推广应用具有十分重要的意义。快速充气所引起的罐内高温会对储氢系统的性能产生很大影响。当罐内温度升高时，其碳纤维外套、铝制内衬以及罐内温度并非相同，所以本文基于Simulink建立了储气罐的集总参数模型来模拟快速充气过程中罐内热力学以及传热过程，并与已有的CFD模型参数进行对比。比较发现集总参数模型得到的各温度曲线跟CFD模型得到的温度变化曲线能够较好地拟合，可

会议

储氢快速充气集总参数计算流体动力学热力学传热

Effect of the alkali/alkali-earth metal hydrides on the thermal decomposition behavior of Mg(BH4)2·2

The ammonia complex of magnesium borohydride Mg(BH4)2·2NH3,which contains 16.0 wt. ％hydrogen and decomposes starting at 150℃,is a very promising material for hydrogen storage[1].However,the release of

会议

The mechanism of improvement of thermal stability of zirconium cobalt-hydrogen system with Ti/Ni/Sc/

The intermetallic compound ZrCo has been considered as a promising substitute of uranium for recovery,storage and supply of gaseous hydrogen isotopes especially tritium for ITER application.The temper

会议

disproportionationelement substitutionhydrogen storage

Preparation of a novel Mg-based hydrogen storage composite nanoconfined by polymethyl methacrylate

A novel nano-confined Mg-based hydrogen storage composite was by mechanical milling of hydriding combustion synthesized (HCS) Mg-based hydride and hydrogen permissive / oxygen prohibitive polymer (Fig

会议

Synergetic catalytic effects of hexagonal boron nitride supported nano-niobium hydride on improving

LiBH4is an attractive material for hydrogen storageowing to its high hydrogen capacity of 18.3wt ％.However,its high thermostability and sluggish kinetics limit its practical application as an onboard

会议

Synthesis of nanoscale RExAly(RE=La, Ce, Pr, Nd) and their high catalytic efficiency for the hydroge

NaAlH4 complex hydride is an attractive material for hydrogen storageowing to its high gravimetric and volumetric hydrogen capacities.However,the poor kinetics and high dehydrogenation temperature ret

会议

Influence of heat treatment on the hydrogen storage performance of Ti1.02Cr1.1Mn0.3Fe0.6 alloy for h

Compared with conventional hydrogen storage techniques,a novel hybrid hydrogen storage vessel (i.e.a high-pressure hydrogen storage vessel combined with metal hydride) provides a technical approach to

会议

Experiment and simulation studies on the thermal characteristics of the hydrogen cylinder walls duri

The temperature rise during the hydrogen filling process is a significant safety concern for the hydrogen cylinders primarily due to the increased susceptibility to fatigue failure of the cylinder wal

会议

High pressure hydrogen storagefast fillingreal gas equationtemperature riseh

氢能源的利用现状分析

氢能是公认的清洁能源，一些发达国家已将氢能列为国家能源体系中的重要组成部分，我国在氢能的研究及产业化方面也投入巨大。本文综合考虑氢能在能源和化工领域的应用，集中讨论了其在清洁能源、能源载体以及化石能源清洁利用3个方面的应用，如图1所示，较为全面地介绍分析了国内外氢能的利用现状。

会议

氢能源清洁能源能源载体化石能源

Anodic diffusion layer with graphene-carbon nanotubes composite material for passive direct methanol

Graphene-carbon nanotubes (G-CNTs) composite material was prepared as the anodic micro porous layer (MPL) carbon material for a passive direct methanol fuel cell (DMFC).The crack-free anodic MPL was o

会议

气体加湿度对质子交换膜燃料电池起动电流的影响实验研究

与本文相关的学术论文