【摘 要】
：
Al-Mg alloys are considered to have potentials to form twins during deformation because Mg has the influence of reducing the intrinsic stacking fault energy ISFE of aluminium.Nevertheless, twinning ha
【机 构】
：
Department of Materials Science and Engineering, Norwegian University of Science and Technology, Nor
【出 处】
：
15th International Conference on Aluminium Alloys(ICAA15)(第十
论文部分内容阅读
Al-Mg alloys are considered to have potentials to form twins during deformation because Mg has the influence of reducing the intrinsic stacking fault energy ISFE of aluminium.Nevertheless, twinning has rarely been found in Al-Mg alloys even subjected to various severe plastic deformation (SPD) techniques, including Equal Channel Angular Pressing (ECAP), Dynamic Plastic Deformation (DPD), High-Pressure Torsion (HPT) etc.
其他文献
T4 process of cold rolled strip in the floater-type furnace has high heat transfer efficiency.In order to study the rapid characteristic, heat transfer equation of strip in floater-type furnace is est
Powder deposition is the main direct energy deposition (DED) additive manufacturing technique.To date, the bulk of the work was carried out on Ti, SS and Superalloys.With respect to Al alloys, the lit
Aluminium profiles show very often an anisotropic deformation behaviour and inhomogeneous properties over cross section especially of thick-wall profiles.The damage behaviour of aluminium profiles dep
The stacking fault energies (SFEs) of various aluminum solid solutions were investigated against temperature and solute concentration using first-principles energy calculations.Three types of impuriti
In through-process simulations of.aluminium sheet production, several physical models are needed to simulate all relevant hardening and softening mechanisms during rolling and annealing.By coupling th
Magnetic pulse welding (MPW) which is one of the impact welding methods is suitable for a wide variety of combinations of similar and dissimilar metals.The flyer plate is accelerated by electromagneti
Aluminum rings with various height/diameter/thickness ratios under axial compression are numerically studied.All the numerical simulations are based on an elastic-viscoplastic constitutive model.The e
The development of ultralight automobile has motivated the lightweight material selection, which has been recognized as a MCDM (multi-criteria decision making) issue, a complex process for its multi-c
Aluminum, with a density of 2.7 g/cm3, is the dominant light metal used in automotive applications today.In this research, a new technology platform is presented to design and manufacture a front rail
In order to describe microstructure evolution during solid-state phase transformation, our previously developed phase-field model with finite interface dissipation was extended for elastically inhomog