【摘 要】
:
The direct transformation of aldehydes with alcohols to esters under mild conditions is an environmentally friendly catalytic process in organic synthesis.The detailed transformation mechanism of meth
【机 构】
:
Institute of Process Engineering,China
【出 处】
:
The 5th Sino-US joint Conference of Chemical Engineering(第五届
论文部分内容阅读
The direct transformation of aldehydes with alcohols to esters under mild conditions is an environmentally friendly catalytic process in organic synthesis.The detailed transformation mechanism of methyl methacrylate (MMA) by methacrolein (MAL) with methanol on Pd catalyst was investigated by DFT calculation as an attempt to gain more insight into the oxidative esterification mechanism and reactivity.
其他文献
Dimethyl ether (DME) is a potential alternative fuel for future diesel engine operation because of its lower NOx emission, near zero smoke amounts, and lesser engine noise compared to conventional die
Quenched solid density functional theory (QSDFT) is a newly proposed DFT method, which takes into account the solid surface roughness and shows more advantages than non-local density functional theory
Based on Euler-Euler computational fluid dynamics (CFD) models, the flow behavior of the TMP riser (120 kt/y) and the traditional riser was compared.Three-dimensional model of the feedstock injection
A rough-cut cyclone or primary cyclone, installed in the FCC riser terminal, operates in a mode different from common cyclones, with its vortex tube and dipleg outlets opened to the same pressure vess
In this paper, two new methods are proposed to intensify liquid-liquid two-phase mass transfer in microchannels.The mixing and mass transfer between liquid-liquid two phases in the microchannel are bo
A novel annular stripper has been proposed by Lu et al.The previous studies showed that the stripping efficiency of annular strippers was significantly higher than that of empty cylinder strippers and
Water-water chillers and Heat pumps are widely used in industry line and buildings to supply cooling and heating.It is very important to develop or design high efficiency, low cost these equipments si
The fluid catalytic cracking (FCC) stripper is the key part connecting reaction and regeneration system, where the oil gases entrained and adsorbed by catalysts are stripped and then enter the disenga
In this work, by using dissipative particle dynamics (DPD) method, the structure and property of the biomembrane which is modeled as bilayer are studied.First, the kinetic process of collision-driven
Circulating fluidized bed (CFB) riser reactors were widely used in chemical industry due to the good heat and mass transfer between gas and solid phase in such kind of reactors.Understanding this kind