正交设计在预分解窑用矿化剂性能评价中的应用

来源 :建材绿色制造先进技术国际交流会 | 被引量 : 0次 | 上传用户：milkchewy

【摘要】

：

高强度熟料是每个水泥生产企业的内在需求.但与之匹配的高率值生料,易烧性过差,影响工艺操作,难以稳定煅烧连续生产.合理使用矿化剂改善易烧性,减轻窑烧成负荷可为预分解窑系统生产高强度熟料开辟新途径.本文研究了适合预分解窑系统的矿化剂,原料全部来自工业废渣和尾矿.建立了以易烧性系数和矿化系数双参数的等级划分,并以此评价矿化剂效果.采用正交试验法对矿化剂因素水平进行了研究,找到了复合矿化剂的最优组合.即带

【作者】

：

王秀龙白波王伟

【机构】

：

天津水泥工业设计研究院有限公司,天津300400

【出处】

：

建材绿色制造先进技术国际交流会

【发表日期】

：

2018年9期

【关键词】

：

水泥熟料矿化剂易烧性矿化系数正交设计

下载到本地 , 更方便阅读

下载此文赞助VIP

声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架

论文部分内容阅读

其他文献

利用脱硫石膏制备石膏基胶凝材料砌块的研究

以利用轮窑及烧结制品余热煅烧脱硫石膏制备的建筑石膏为主要原料,通过掺加粉煤灰、水泥、矿渣粉掺和料后,在石灰的激发下制备石膏基胶凝材料及制品.利用正交试验研究了各掺加料对胶凝材料强度的影响,研究了制备石膏砌块的可行性,并通过XRD和SEM分析了改善胶凝材料强度的机理.结果表明,粉煤灰和矿渣粉的掺加量是影响胶凝材料强度的关键因素;以建筑石膏75.0％、粉煤灰12.0％、矿渣粉3.0％、水泥7.0％、石

会议

石膏砌块制备工艺配合比材料强度

干粉煤灰掺量对立磨粉磨水泥的影响

粉煤灰在水泥中已被广泛应用,对于添加干粉煤灰的水泥立磨,通过实验室半工业化立磨和工业化生产的分析,得到如下结论:在水泥立磨粉磨中,掺入低于40％的干粉煤灰,每增加1％,粉磨电耗降低0.16kWh/t,可作为选型设计参考;每增加1％的干粉煤灰,产品比表面积会有不同程度的增加.

会议

水泥制备立磨工艺设备选型干粉煤灰掺杂量

Evaluation of metastable degree in amorphous Al2O3-ZrO2-Y2O3 and its effect on plastic deformation

Novel plastic deformation was exhibited in amorphous oxides,attributed to the metastable state of amorphous phase with free volume and disordering structure;however,metastable degrees can be quite dif

会议

PlasticityAmorphous materialsMetastable degreeShear band

Influence of fibers on the microstructure and compressive response of directional ice-templated alum

Directional ice-templated ceramics have unique lamellar porous channels between ceramic walls which run from bottom to top of the samples.This highly oriented morphology results in the anisotropy in m

会议

Directional ice-templated porous ceramicsFiber bridgeslamellar wallsAnisotrop

印尼海德堡P14万吨线烧成系统的优化设计与运行

印尼海德堡P14项目烧成系统采用了国产化的万吨级预分解系统和万吨级回转窑.针对印尼当地高水分原料和高水分褐煤的特点,对预热器、分解炉、回转窑等设备进行了优化设计.实际运行结果反馈,烧成系统能耗指标和环保指标均达到同规模生产线的先进水平,顺利通过性能考核.

会议

水泥制备烧成系统优化设计能耗控制

Preparation of Homogeneous Mullite Based Fibrous Ceramics by Starch Consolidation

Silica sol is one of the frequently-used binders in high-temperature resistingfibrous porous ceramics,but in the drying process,it can diffuse with water and influencethe uniformity of ceramics.To sol

会议

FibersMulliteStructural applicationsSilicaStarch consolidation

The formation mechanism of mullite whisker in the mullite fiber network

The influences of different fibers and F ions on the formation mechanism of hierarchical structure were investigated.This study was undertaken to better understand how fibers affect the growth of mull

会议

mullite whiskersfluoridescrystallizationaluminosilicates

A heat-resistant preceramic polymer with broad working temperature range for silicon carbide joining

A room temperature curable heat-resistant adhesive with broad working temperature rangewas prepared through organic and inorganic modification.The preceramic polymethylsiloxane showedlow bonding stren

会议

Heat-resistanttemperature rangesilicon carbidecopolymerizationfillers

MoSi2-borosilicate glass coating on fibrous ceramics prepared by in-situ reaction method forinfrared

MoSi2-borosilicate glass coating with MoSi2 as emittance agent was prepared on mullite fibrous ceramics for enhanced superficial infrared radiation via an in-situ reaction method.The phase and structu

会议

MoSi2-glass coatingInfrared radiationImpact resistanceThermal shock resistanc

Comparative Study of MoSi2-Borosilicate Glass Coatings on Fibrous Ceramics Prepared by In-situ React

Two infrared radiating coatings with borosilicate glass as binder and MoSi2 as emittance agent were prepared on mullite fibrous ceramics by an in-situ reaction method and a two-step method,respectivel

会议

Coating materialsSinteringOxidationMechanical propertiesRadiation effects

正交设计在预分解窑用矿化剂性能评价中的应用

与本文相关的学术论文