【摘 要】
：
A large number of studies have been conducted on bolted flange joints using finite element (FE) method,where various types of nonlinear FE models are developed.Those FE models are used extensively to
【机 构】
：
Department of Mechanical Engineering, Tsinghua University, Beijing
【出 处】
：
The 5th International Conference on Dynamics, Vibration and
论文部分内容阅读
A large number of studies have been conducted on bolted flange joints using finite element (FE) method,where various types of nonlinear FE models are developed.Those FE models are used extensively to predict the joint strength and sealing properties;whereas,little attempt has been undertaken to employ nonlinear FE models in dynamic analysis of bolted flange joints.
其他文献
The technique of single-cell sequence has been extensively used in molecular biology in measuring the genomic transcriptome at single cell level.On the other hand,for many complex diseases,the cell po
This paper investigates the synchronization problem between two complex networks with non-derivative and derivative coupling by employing aperiodically intermittent pinning control.
Time-delays naturally occur in genetic phenotype control systems primarily due to the spatial separation between the DNA transcription process occurring in the nucleus of eukaryotes and the mRNA trans
It has been widely recognized that networks is a good tool for describing various artificial and natural systems.Thus,a natural problem arises: how to construct networks and further properly study its
The transverse vibration of a rotating tapered beam under the excitation of wake flows are considered.The integro-partial differential equation of the beam is obtained and discretized by using the Gal
A launch vehicle is always used to put payloads of different weights into orbits.However,we only test modal parameters of the launch vehicle once with the typical payload.
Nonlinear reduced-order modeling approaches have been a promising tool of predicting the transonic aerodynamic and aeroelastic behaviors of aircraft structures.However,the accuracy of the approaches i
I.Introduction Grid fins,also commonly known as lattice fins,is an unconventional lifting and control surface consisting of an outer flame supporting an inner grid of intersecting small chord planar s
Most of the existing study work on vibration of shell are limited to classical axisymmetric boundary conditions,but many non-axisymmetric boundary conditions are encountered in engineering practice.
Four dimensional (4D) Euler equation with four first order differential equations for rigid-body or incompressible fluid is still blank,which is great valuable in generalized 4D Hamiltonian system of