2. 您的位置
3. 首页
4. 会议论文
5. CALORIMETRIC MEASUREMENT OF GROUND SOURCE HEAT PUMP SYSTEM USING DIRECT EXPANSION METHOD -MEASUREMEN

CALORIMETRIC MEASUREMENT OF GROUND SOURCE HEAT PUMP SYSTEM USING DIRECT EXPANSION METHOD -MEASUREMEN

来源 :2016冷冻空调亚洲大会(8th Asian Conference on Refrigeration and Air-c | 被引量 : 0次 | 上传用户：wanglinux_0208

【摘 要】

：

The GSHP that use a direct expansion method is expected to have higher performance of energy-saving than the conventional type of the GSHP.We evaluated the quantity of heat by measuring temperature,hu

【作 者】

：

S.Amano S.Funatani T.Takeda S.Ishiguro K.Ichimiya D.Tanaka 

【机 构】

：

Department of Medicine and Mechanical Engineering,University of Yamanashi Takeda 4-3-11,Kofu,Yamanas

【出 处】

：

2016冷冻空调亚洲大会(8th Asian Conference on Refrigeration and Air-c

【发表日期】

：

2016年3期

下载到本地 , 更方便阅读

下载此文 赞助VIP

声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架

论文部分内容阅读

　　The GSHP that use a direct expansion method is expected to have higher performance of energy-saving than the conventional type of the GSHP.We evaluated the quantity of heat by measuring temperature,humidity and flow rate at the indoor unit of the GSHP system.

其他文献

COMBINED CONVECTION HEAT TRANSFER OF MICRO-CAPSULE SLURRY IN A HORIZONTAL DUCT

Identifying phenomena such as natural convection and forced convection has become indispensable when designing heat exchanger and heat pipe ramp,etc.However there has been barely any basic research on

会议

Development of an energy simulation software for high-tech fabrication plants(1):theoretical model

High-tech manufacturing consumes huge of energy.For example,a 12 in DRAM(Dynamic Random Access Memory)semiconductor wafer fabrication plant(hereafter referred "fab")consumes about 400,000 MWh annually

会议

Development of a High-Tech.Fab Energy Simulation(FES)Software:(2)Using FES as an energy analysis too

In our companion paper [1],the mathematical model and verification of the FES program are elaborated.In this paper,the application of FES is demonstrated by evaluating the effect of 6 energy-saving ap

会议

Research of Energy Consumption by Outdoor Infiltration Quantity and Negative Pressure in Cleanroom S

Taiwan computer appliances and audiovisual electronic manufacturing industries use 43.9 billion kWh of electricity,which takes up 17.5%of all the electricity usage in Taiwan.This shows that it has a b

会议

EXPERIMENT AND CFD SIMULATION OF BOILING HEAT TRANSFER COEFFICIENT OF R32 IN MINICHANNEL

This study demonstrates the experimental heat transfer coefficient and computational fluid dynamic(CFD)simulation of two-phase flow boiling of R32 in small tube.The experimental data were conducted in

会议

EXPERIMENTAL INVESTIGATION OF A DESICCANT DEVICE INTEGRATED WITH HEAT PIPE HEAT EXCHANGER

This work presents an experimental investigation of a desiccant device integrated with heat pipe heat exchanger.Drying rate of the conventional hot air dryer is significantly affected by the differenc

会议

Performance Evaluation of Ground Source Heat Pump Using Direct Expansion Method-In case of 48 hours

This paper describes the experimental results and the performance of ground source heat pump using the direct expansion method.The underground temperatures are more stable than air temperature.The tem

会议

A TRAINING DATA OPTIMAL STRATEGY BASED ON CLUSTER ANALYSIS FOR THE PCA-BASED CHILLER SENSOR FAULT DE

Healthy sensors are essential for normal and optimal operation of HVAC&R systems.Various data-based methods are employed widely for sensor fault detection,diagnosis and error data reconstruction nowad

会议

INVESTIGATION OF HEAT PUMP SYSTEM FOR ELECTRIC VEHICLES

The electric vehicles are an automobile propelled by electric power and has the advantage of zero emission on the road.With its energy-saving,low pollution,and efficient mobility benefits,the electric

会议

Indoor Wireless Transmission Path Loss Channel Model Measurement and Construction of Wind Variabilit

This paper aims to develop a wind variability control system by using(Received signal strength indicator)RSSI information.We make field measurement of the path loss in the Bluetooth wireless transmiss

会议