【摘 要】
：
As newer active and passive safety systems are developed, new testing requirements have appeared along with constraints and requirements that must be overcome while at the same time maintaining higher
【机 构】
：
Applus + IDIADA,spain
论文部分内容阅读
As newer active and passive safety systems are developed, new testing requirements have appeared along with constraints and requirements that must be overcome while at the same time maintaining higher safety and quality standards.This paper presents a modular system that makes it possible to automate hazardous tests for drivers by using path following by means of a low-cost camera or defined GPS trajectories.This project provides a solution to tests where the driver cannot be inside the vehicle due to the inherent risk and complex methodology that must be followed.The developed system, which can be installed in any vehicle, is mounted on a small pick-up truck, which is used as a test vehicle.Once this control architecture has been implemented, installed and tuned, the resulting steering manoeuvring allows tests required for recently developed and future safety systems to be performed.The experimental results show that the combination of artificial vision algorithms and steering wheel controller are capable of managing the lateral guidance of a vehicle as a human driver would do.
其他文献
The improvement of formability by pulsating hydroforming process of 6016 aluminium alloy tubular part of one car is examined using finite element simulation.The effects of the amplitude and cycle numb
The assembly effect of automotive exterior parts directly affects the automobile modelling design, and the gap and flush of automotive exterior parts is essential to evaluate assembly effect of auto e
The related concepts of dimension "2MM" engineering of the automotive products are introduced.The dimension design "2MM" engineering is the foundation of vehicle dimension manufacturing "2MM" project.
Based on the ECE R66 standard, a FEM model of a school bus was established and the rollover crash was simulated by LS-DYNA.According to the inbreak criterion of living space and the deformation level
It is effective method to reduce resonance of shaft to installs an absorber on it.And the performance of the absorber is due to its design parameters.The modal parameters are identified by component a
The dynamic behavior of the valvetrains for a gasoline engine is simulated by using a multi-valvetrain dynamic model, of which the stiff parameters are caculated by finite element method.Then, the sim
There are two main reasons for turbocharger whine noise in vehicle, unbalance and pressure pulsation, and they have the same characteristic but different mechanism.The different methods are studied in
Based on the mechanism of secondary couple caused by cardan joint, this paper analyzes the reasons for the secondary couple and 2nd order vibration of a 4WD driveline resulting from cardan joint excit
Based on the purpose of pedestrian protection, a new Pop-up Engine Hood System (PEHS) with an effect of elastic butter is developed to reduce the injury of pedestrians in unavoidable human-car collisi
The road bank angle and roll angle have direct influence on the vehicles lateral motion.As a result, the accuracy of sideslip angle estimation can be improved through estimation of road bank angle and