2. 您的位置
3. 首页
4. 会议论文
5. The Influence of CaO Content on Mechanical Properties of Geopolymer concrete

The Influence of CaO Content on Mechanical Properties of Geopolymer concrete

来源 :The 8th International Symposium on Cement & Concrete(ISCC 20 | 被引量 : 0次 | 上传用户：bigfishing

【摘 要】

：

Geopolymer with different CaO content was produced,of which metakaolin,slag and fly ash were used as raw material,low modulus water glass(sodium silicate)was used as alkali-activator and the influence

【作 者】

：

Qing Wang Zhaoyang Ding Kun Ran Taojun Wu 

【机 构】

：

School of Materials Science and Engineering,Shenyang Jianzhu University,Shenyang,China 110168

【出 处】

：

The 8th International Symposium on Cement & Concrete(ISCC 20

【发表日期】

：

2013年4期

【关键词】

：

Metakaolin Slag Fly ash Geopolymer concrete CaO content 

下载到本地 , 更方便阅读

下载此文 赞助VIP

声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架

论文部分内容阅读

　　Geopolymer with different CaO content was produced,of which metakaolin,slag and fly ash were used as raw material,low modulus water glass(sodium silicate)was used as alkali-activator and the influence of CaO content on mechanical properties of geopolymer concrete was studied.

其他文献

Investigation on Over-Sulfur Phosphogypsum-Ground Granulate Blast-Furnace Slag Cement Paste and Conc

This study investigated a new type of cementitious material(over-sulfur phosphogypsum(PG)–ground granulate blast-furnace slag(GGBFS)cement paste)by utilizing ground granulated blast-furnace slag,Portl

会议

Modificated phosphogypsum pasteSteel slaghydration product

Research on the Performance of Steel Slag Sand Dry-mixed Plaster

With the rapid development of China infrastructure construction and wide awareness about environmental protection,the natural river sand resources have been fewer and fewer,so how to use the slag as a

会议

steel slag sandplasterdesign strengthmechanical properties

Preparation and Cost Analysis of Steel Slag Sand Thin Masonry Mortar

Steel slag sand thin masonry mortar can be prepared by steel slag sand when the range of particle size is 0-0.6mm,1%redispersible latex powder and 0.1%cellulose ether with 100000mPa.s viscosity.

会议

steel slag sandthin-layer masonry mortarmix designcost analysis

The Experimental Study of Phosphogypsum-based Binder Filling Material

The paper is about researching of a new binder filling material by the main raw material of phosphogypsum(PG).This paper analyzed the relation between the various components of system and the properti

会议

phosphogypsumfilling materialSolid waste utilization

Research on the Physicochemical Properties of C3S With Ball Milling

The authors used the laser granularity survey technology,X-ray powder diffraction,scanning electron microscopy(SEM)and infrared spectrum analysis methods,mechanochemical effect and hydration activity

会议

tricalcium silicatemechanochemical effectcrystal microscopic structurehydrati

Influence of Steel Slag on Silicate Clinker Sintering

Steel slag is an industrial waste formed in the process of steelmaking,15%-20%of steel production.It can take the place of iron correction material in cement sintering because of its high iron content

会议

steel slagsilicate clinkerstrengthburning-abilitymicrostructure

Research On the Hydration Kinetics Process of the Cement Complex with Fly Ash,Slag and Silica Fume

Using the calorimetry,X-ray diffraction(XRD)and scanning electron microscopy(SEM)on the mixed double mixing material of cement hydration heat release characteristics of hydration products and microstr

会议

cement-based materialshydration processdynamics

Hydrothermal Synthesis of High Strength Hardened Calcium Silicate Samples Using Fly Ash

The effect of substituting fly ash for silica fume used as raw material in the hydrothermal synthesis of hardened calcium silicate hydrate material with low water to power ratio was investigated.Fly a

会议

Hydrothermal reactionsfly ashtobermoritelow water to power ratio

Dissolution and Adsorption Behaviors of Sulphate in Portland Cement Early Hydration

Sulfate of Portland cement paste dissolves into aqueous phase to participate in cement hydration and a small part would be adsorbed on C-S-H gel usually for high curing temperatures at early hydration

会议

sulfate ionsC-S-H samplesdissolutionadsorption

Experimental Study on Formwork Pressure Exerted by Self-Compacting Concrete

In this study,an experiment was taken to simulate the self-compacting concrete(SCC)formwork pressure over time by varying the casting rate and formwork width.In order to apply SCC to Double-Wall Preca

会议

self-compacting concreteDouble-Wall Precast Concreteshear wallcasting ratefo