【摘 要】
：
In this study we focused on the influence of nano-size B4C particles (～60 nm) on microstructure and mechanical behavior of Al-2024/B4C composites.The experiment involved ball milling of 2024-Al and B4
【机 构】
：
Beihang University, China Ritsumeikan University,
【出 处】
：
15th International Conference on Aluminium Alloys(ICAA15)(第十
论文部分内容阅读
In this study we focused on the influence of nano-size B4C particles (～60 nm) on microstructure and mechanical behavior of Al-2024/B4C composites.The experiment involved ball milling of 2024-Al and B4C powders followed by spark plasma sintering (SPS) and rolling.The microstructures of composite before and after rolling were characterized by X-Ray diffraction (XRD), scanning electron microscope (SEM) and Electron Backscattered Diffraction (EBSD).
其他文献
Replacing steel plate with aluminum alloy as automotive panel is a cost-effective way to reduce body weight.Unfortunately in industrial production, it is not possible to avoid natural aging which is h
A kind of N doped Al-4wt.％Ti-1wt.％ C (Al-4Ti-1C-N for short) master alloy was prepared and its phase component and microstructure were characterized by X-ray diffractometer (XRD), field emission scann
Microstructure of high strength aluminium alloy have determinant effect on the properties, thus an effort has been made to investigation the relationship between fracture toughness and quantitative ch
Using Gleeeble-1500, a systematic experimental study for the effect of the temperature and heating rate on the mechanical properties of A5052 aluminium ahoy was investigated.In this experiment, specim
Al-Cu-Mg alloy (Duralumin) has a high strength and used in aerospace industry from the early 19th century.Traditionally, it has been strengthened by dispersed fine precipitates.3 decades ago, severe p
A novel thermomechanical treatment was proposed for increasing the strength of 6156 aluminum alloy while maintaining a high elongation, which is based on artificial aging at low temperature, cold roll
Al-Mg-Si alloy has been strengthened by aging treatment and used as structural materials.Transition metals (TM) are conventionally added to Al alloys for grain refinement.In this research, several TMs
This paper studied morphology and structure of iron-rich phase in the aluminium alloy using electrolytic separation technology, which content of iron was 0.3%, 0.6%, 1%, 0.6%, 2% and 5%.Results showed
Cu and Ag addition to Al alloys can enhance its mechanical properties due to solid solution hardening and precipitation hardening by aging treatment.Alloying elements affect a precipitation sequence a
Wire-Arc Additive Manufacturing (WAAM) is highly efficient, can achieve high deposition rates and does not rely on expensive equipment.WAAM thus has the potential to produce large scale, near net-shap