SIMULATION AND ECONOMIC EVALUATION OF SOLAR COOLING SYSTEMS IN HOT-SUMMER AND COLD-WINTER ZONE

来源 :2016国际制冷空调技术交流会 | 被引量 : 0次 | 上传用户:hlj123456789001
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
  The building energy consumption has distinctly increased in hot-summer and cold-winter zone in China.Solar cooling technology has been developed to reduce the increasing electricity consumption for air conditioning and to shift the peak load in hot summer days.This paper presents a performance simulation and economic analysis for both PV and thermal solar cooling systems compared to a reference system,which is composed of two heat pumps driven by electricity.The results shows that 27.3%and 25.9%of primary energy can be saved by using the PV system and by using the thermal system respectively.The payback time is seven years for the PV system,but more than twenty years for the thermal system under the current conditions.Therefore,the PV system is more suitable for the practical application in hot-summer and cold-winter zone.The thermal system could be an alternative when the middle-and high-temperature solar thermal collector technology have been further developed,as well as smalland middle-sized chillers would go into mass production.
其他文献
针对目前冷藏车运输成本较高的问题,本文提出了新型发动机烟气余热驱动的吸附式冷藏车制冷系统,由中温盐CaCl2吸附床、高温盐MnCl2吸附床、蒸发器、冷凝器、膨胀阀和储液罐等组成.本文不仅进行台架实验研究,而且完成了装车实验研究,实现了实验室研究向工程应用的突破,台架实验显示蒸发器最低出风温度能够达到-25℃,当蒸发器的出风温度为-5℃,整周期的平均制冷量为2.32kW.装车实验结果显示当蒸发器出风
本文试验研究了润滑油对半封闭螺杆制冷压缩机性能的影响,首先对压缩机油路系统进行改造,实现了不同工况下吸、排气端轴承供油量及吸气管回油量的测量及调节.此外,录取了压缩机在不同润滑油循环流量下运行时的p-V示功图,分析讨论了吸、排气端轴承供油以及吸气管回油对压缩机宏观性能和微观工作过程的影响机制.
As the dust particle deposition on wavy fin-and-tube heat exchangers may increase the pressure drop and deteriorate the heat transfer performance,a numerical model for predicting the particle depositi
The offset angle of the upper and lower part of the crankshaft will affect the resistance of discharge of low pressure stage cylinder and suction of high pressure stage cylinder in the rotary two-stag
会议
To quickly design a microgroove room air conditioner,a heat exchanger model applicable for system simulation with fast speed,high accuracy and versatility is needed.This paper presents a graph-theory
本文对R410A双级压缩经济器系统的两种补气方式——过冷前节流补气和过冷后节流补气进行了循环理论分析及对比实验研究,研究分析了补气支路流量、室外工况对系统性能的影响.结果表明:随着补气量的增加,补气支路出口状态呈现出从过热到饱和再到两相的变化趋势,出口饱和状态时系统能力能效最高;额定制冷工况下,过冷后节流补气系统和过冷前节流补气系统制冷量分别比关补气系统提高了10.2%、8.8%,其EER分别提高
Building a dynamic simulation model of the centrifugal chiller in consideration of control processes is highly important for evaluating all-year performance of the chiller.A dynamic simulation model o
This paper presents a novel sensor fault detection and diagnosis(FDD)for screw chiller system using a oneclass classification algorithm,support vector data description(SVDD).It has advantages of solvi
本文建立了单级压缩、单级压缩带回热、双级压缩两级节流中间闪发补气和单级压缩两相喷射膨胀四种典型CO2跨临界循环的热力循环分析模型,采用EES编程进行计算,较为全面地分析给出每种循环的制热量、COP、排气温度、质量流量、单位质量制热量等随蒸发温度、气冷器出温度、排气压力、双级压缩的排量比等参数的影响特性.同时分析给出单级压缩跨临界循环最优排气压力受主要影响参数的影响规律.
分析了地铁车站夏季采用常规空调存在的不足,提出了一种以污水源热泵作为冷源的温湿度独立控制空调系统,给出了系统设备形式,并介绍了系统工作原理.以某地铁车站为例,分析了夏季空调负荷组成,并根据拟定设计参数计算地铁车站夏季空调负荷.从系统初投资和运行费用方面,对常规空调和温湿度独立控制空调做了经济性对比.结果表明温湿度独立控制空调系统初投资虽然较常规空调高,但其运行费用明显低于常规空调,约为常规空调的6