2. 您的位置
3. 首页
4. 会议论文
5. Investigation of Helmholtz Coils for Edge Structure Using Inductive Thermography

Investigation of Helmholtz Coils for Edge Structure Using Inductive Thermography

来源 :The 2nd International Conference on Structural Health Monito | 被引量 : 0次 | 上传用户：chrisl0708

【摘 要】

：

Structural health monitoring(SHM)is a crucial concern in engineering,which sets out to determine the health of a structure by reading information from an array of sensors that are embedded into the st

【作 者】

：

WANG Yi-zhe GAO Bin TIAN Gui-yun 

【机 构】

：

School of Automation,University of Electronic Science and Technology of China,Chengdu,China

【出 处】

：

The 2nd International Conference on Structural Health Monito

【发表日期】

：

2014年5期

【关键词】

：

helmholtz coils complex geometry edge structure inductive thermography structura 

下载到本地 , 更方便阅读

下载此文 赞助VIP

声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架

论文部分内容阅读

　　Structural health monitoring(SHM)is a crucial concern in engineering,which sets out to determine the health of a structure by reading information from an array of sensors that are embedded into the structure and monitored over time.Therefore,advanced nondestructive testing(NDT)is essential as a front end of SHM.

其他文献

Stress Monitoring Method Based on Image Measurement

This paper attempts to establish a new approach: based on computer graphics measure and finite element method,through one or more camera to obtain displacement of characteristic points on structures,t

会议

stress monitoringimage measurement

Binocular Stereo Vision Measurement System Based on SOPC

A measurement system based on binocular stereo vision is developed to judge the distance between two adjacent automobiles in the field of automobile safety.This paper proposes a complete stereo vision

会议

binocular stereo visionSOPCNios Ⅱvehicle safetymeasurement system

Array Displacement Measurement System based on MEMS Technology and Its Application in Geotechnical E

Array displacement measurement system is a kind of high-end sensor technology based on MEMS technology,which can get continuous deformation information distributed.This technology has a series of adva

会议

array displacement measurementMEMSgeotechnical engineeringmonitor

The Development of RFID Tag Antenna-Based Sensor for Crack Determination

Recently,the feasibility of detecting crack in metal by radio frequency identification(RFID)tag antenna-based sensor(TABS)is widely studied in open literatures; however,little concern is paid on the c

会议

structural health monitoring (SHM)nondestructive testing & evaluation (NDT&E)c

Research on the Residual Stress Measurement in Steel Plate Using LCR Ultrasonic Wave Based on the Ph

The thin plate that uniaxial tensile stress loaded was used as the object in this paper.It adopt the critically refracted longitudinal(LCR)wave which based on the improved acoustic-elasticity theory a

会议

thin plateresidual stressLCR wavestress measurement

Analyze the Meter Reading Success Ratio of Low-Voltage Power Carrier with Gross Error Elimination Me

At present,Yunnan power line cartier technology is about 73.7% in user acquisition local communication,and the average success rate of reading meter is about 75%.According to the principle of gross er

会议

wireless gross error elimination methodlow-voltage power line carriersuccess r

Crack Detection in Beams Using Stationary Wavelet Transform-Aided Fractal Dimension Analysis: Experi

Identification of slight damage from measured dynamic responses incorporating significant noise is an ongoing challenge in the field of structural health monitoring,potentially requiting sophisticated

会议

damage detectionmode shapestationary wavelet transformfractal dimensionnoise

Signal Acquisition of Structure Impact and Its Locating Experiment Based on Piezoelectric Sensor Tag

In order to solve problems of wired monitoring of structure impact damage such as large amount of wiring,high cost of installation or maintenance,and poor flexibility,a method of acquiring signal of s

会议

structure impact locatingwireless monitoringpiezoelectric sensor tagwavelet a

The Research of Excitation Frequency Selection in Barkhausen Noise Detection for RPV Irradiation Emb

Against the background of RPV irradiation embrittlement,this paper introduces the principle of Barkhausen noise detection and the design of detecting system of RPV irradiation embrittlement.Experiment

会议

Barkhausen noise technologyRPVexcitationfrequencyenvelope

Sparsity-Enabled Denoising Method Based on Tunable Q-factor Wavelet Transform for Bearing Fault Diag

Fault diagnosis of rolling element beatings is of great importance to maintain the high reliability and long-term safe operation of rotating machinery.However,the weak fault feature is usually submerg

会议

beating fault diagnosissparsity-enabled denoising methodtunable Q-factor wavel