论文部分内容阅读
在钢球上磨削圆柱面的简易方法是这样的:清洗钢球,去除其表面的油污和杂质。将502胶水均匀涂在简易夹具(见图)的锥坑面上。钢球放在涂胶后的夹具锥坑上,用手旋加5oN左右的力旋转几周,使得涂胶层厚度均匀,保证加工的外圆与球面的同轴度,施力时间为1min。将结合牢固的钢球及夹具夹入外圆磨床的卡盘上,右面用平顶尖施5oN左右的力顶住钢球,以避免502胶的粘结强度不够而造成
The easiest way to grind a cylinder on a steel ball is to clean the ball and remove oil and impurities from its surface. The 502 glue evenly coated on the simple fixture (see photo) taper pit surface. The steel ball is placed on the conical pit of the jig after coating, and the force is rotated by hand for about 5oN for a few weeks to make the thickness of the coating uniform, which ensures the concentricity of the processed outer circle and the spherical surface. The force time is 1 min. Will be combined with a solid steel ball and clamp into the cylindrical grinder chuck, the right with a flat tip Shi Shi around 5oN force to withstand the ball, in order to avoid 502 adhesive bond strength is not enough