【摘 要】
：
The material flow, temperature rise of the billet and pressing load during equal-channel angular process (ECAP) were studied by using 3D finite element method f
【机 构】
：
Department of Materials Science and Engineering
论文部分内容阅读
The material flow, temperature rise of the billet and pressing load during equal-channel angular process (ECAP) were studied by using 3D finite element method for Cu at different corner angle of mold, interfacial friction coefficient between the billet and the mold. As corner angle increases, the magnitude of shear deformation decreases and the strain difference between upper and lower part of the material becomes more apparent. The pressing load and peak temperature rise of the billet become low as the interfacial friction coefficient decreases. The effects of the corner angle of mold on the temperature rise of the billet can be ignored, but the effects of the friction coefficient between the mold and the billet must be taken into account. For pressing load, the effect of the friction coefficient is larger than that of the corner angle. A good agreement between the simulated and measured material flow is obtained.
其他文献
Mg-6Al-4RE-0.4Mn (mass fraction, %, RE=Ce rich mischmetal) alloy was prepared by steel mould casting technique. Solid solution and artificial aging (T6) were ca
Y-shaped structure was synthesized by ethanol catalytic combustion(ECC) technique on the copper plate substrate,without directly seeding catalyst into the flame
Mg-(5-22)(mass fraction, %)Li alloys with Zn addition were produced and studied. The density of studied alloys is 1.19- 1.62 g/cm3. It is found that the alloy h
InAs quantum dots (QDs) grown on InxGa1-xAs/InP matrix by low pressure metal organic vapor phase epitaxy (LP-MOVPE) in nitrogen ambient were studied. Formation
Single crystals of Ca3NbGa3Si2O14 (CNGS) with ordered Ca3Ga2Ge4O14 (CGG) structure were successfully grown from stoichiometric melts by conventional Czochralski
The acid treatment process,testing methods,microstrcture of sepiolite mineral materials and their adsorbing properties to dodecanol were studied respectively. T
The semi-solid compression deformation behaviour of Y112 die casting aluminum alloy with nondendritic structure obtained under the semi-solid isothermal treatme
The equations of hydrogen solubility in pure magnesium and its alloy were deduced based on thermodynamic analysis: for pure magnesium, lgc(H)=0.5lg p(H2)-1 332/
The effects of electric field intensity and treatment temperature on the microstructures of GH4199 superalloy after long-term aging were investigated. The resul
Two series of solid complexes of europium and terbium with biphenyl 4-carboxylic acid and phen were synthesized and characterized in this report. Their elementa