The effects of sulfur addition methods and Ca-Si treatment on the microstructure and properties of free-cutting non-quenched and tempered steel 30Mn VS were investigated by using optical microscopy, SEM and tensile test methods. The results show that sulfur addition methods influence the morphology of sulfides and the properties of 30Mn VS slightly. Ca-Si treatment is beneficial for the formation of complex sulfides which normally have oxide cores, therefore, improving the distribution of sulfides in the tested steel and enhancing its toughness. The two methods, pyrite addition during LF process and S wire feeding during VD process,slightly influence the morphology and distribution of sulfides and the properties of 30Mn VS; Ca addition not only promotes the nucleation of sulfides on the cores of calcium aluminate inclusions,but also creates modification effect on MnS, reducing the relative plasticity and hot deformability of sulfides during hot rolling process,thereby reducing the length/width value of sulfides and improving their distribution, and significantly enhancing its mechanical properties, in particular, the impact toughness increased by 30%.