Saturated absorption of different layered Bi2Se3 films in the resonance zone

来源 :PhotonicsResearch | 被引量 : 0次 | 上传用户:candy136892
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
Here, we used the micro P-scan method to investigate the saturated absorption (SA) of different layered Bi2Se3 continuous films. Through resonance excitation, first, we studied the influence of the second surface state (SS) on SA. The second SS resonance excitation (2.07eV) resulted in a free carrier cross section that was 4 orders of magnitude larger than usual. At the same time, we found that the fast relaxation process of the massless Dirac electrons is much shorter than that of electrons in bulk states. Moreover, the second SS excitation resonance reduced the saturation intensity. Second, we studied the effect of the thickness on the SA properties of materials. The results showed that the saturation intensity was positively correlated to the thickness, the same as the modulation depth, and the thicker the Bi2Se3 film was, the less the second SS would influence it. This work demonstrated that by using Bi2Se3 as a saturable absorber through changing the thickness or excitation wavelength, a controllable SA could be achieved.
其他文献
Encoding information using the topological charge of vortex beams has been proposed for optical communications. The conservation of the topological charge on propagation and the detection of the topological charge by a receiver are significant in these ap
本文推导了任一空间光线经过Wollaston棱镜的相位延迟公式,分析了特殊情况下会聚光束经过棱镜的相位延迟分布。
A widely tunable high precision chaotic fiber laser is proposed and experimentally demonstrated. A tunable fiber Bragg grating (TFBG) filter is used as a tuning element to determine the turning range from 1533 nm to 1558 nm with a linewidth of 0.5 nm at a
期刊
对于许多实验来说,发现需要同时,即在时间间隔不过109分之几秒的时间内,运转几台巨脉冲激光器。我们想报导在短于3×10-9秒的时间内,同时发射光脉冲(每个的半宽度约10毫微秒)的两台巨脉冲激光器成功的运转。
期刊
本文提出一种计算相变型光盘膜系光学特性的方法.并以TeSbSe光记录介质为例,讨论了三层膜相变光盘的优化设计.
In order to achieve higher spectral efficiency, mode division multiplexing (MDM) in few-mode fibers is a new research area. The idea faces lots of technical issues including intermodal delay and mode coupling which limit the achievable length of the syste
期刊
期刊
基于可视化观察,研究了光纤激光-TIG电弧复合焊接等离子体的多重形貌特征。结果表明:基于等离子体光强的非均匀分布特性,利用多重成像法可同时观测出复合焊接等离子体的三重像和四重像,并可区分出金属等离子体和电弧等离子体,而且采用氦气保护比采用氩气保护更易于区分;在相同的电弧电流和成像条件下,复合焊接等离子体的面积明显大于单电弧焊接等离子体的面积;TIG电弧-激光复合焊接等离子体的面积明显大于激光-TIG电弧复合焊接等离子体的面积;复合焊接等离子体中金属等离子体与保护气并未充分混合,金属等离子体对复合焊接等离子
对激光烧结制备钛酸铋Bi4Ti3O12陶瓷进行了研究。采用CO2激光直接辐照Bi4Ti3O12陶瓷素坯表面, 激光功率密度为20~30 W/cm2, 烧结温度为1000 ℃左右。与传统固相反应烧结技术制备的Bi4Ti3O12陶瓷相比, 激光烧结制备的Bi4Ti3O12陶瓷致密度较高, 相对密度能达到95%, 压电性能提高了约60%, 铁电性能的增强表现在矫顽场的明显减小和易于极化。通过X射线衍射、扫描电镜分析了激光烧结Bi4Ti3O12陶瓷的物相、显微结构和电性能改变的机理。实验现象和结果表明, 激光烧结
期刊