多模半导体激光器在光反馈条件下的低频波动

来源 :ChineseOpticsLetters | 被引量 : 0次 | 上传用户:cardio
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
Dynamics of a semiconductor laser subject to moderate optical feedback operating in the low-frequency fluctuation regime is numerically investigated. Multimode Lang-Kobayashi (LK) equations show that the low-frequency intensity dropout including the total intensity and sub-modes intensity is accompanied by sudden dropout simultaneously, which is in good agreement with experimental observation. The power fluctuation is quite annoying in practical applications, therefore it becomes important to study the mechanism of power fluctuation. It is also shown that many factors, such as spontaneous emission noise and feedback parameter, may influence power fluctuation larger than previously expected.
其他文献
介绍了沃利斯和波米伦兹(Wallis,Pomerantz)静电密封技术在低温玻璃-玻璃真空坚固光学窗口密封中的应用。描述了真空坚固的石英光学窗口与制成布儒斯特角的石英管的成功的密封,确定了问题的范围。扼要讨论了密封机理,并确定了一般方程。
期刊
本文详细地研究了Ho3 :Gd3Ga5O12(以下简称Ho3 :GGG)中Ho3 离子在0.5~3.0μm波段内的室温及77K温度下的荧光光谱。根据Judd—Ofelt理论,计算了Ho3 离子的自发辐射电偶跃迁几率与辐射寿命等光谱强度参数。
We demonstrate fast time-division color electroholography using a multiple-graphics-processing-unit(GPU) cluster system with a spatial light modulator and a controller to switch the color of the recon
期刊
期刊
期刊
A new fabrication technology for three-dimensionally buried silica on silicon optical waveguide based on deep etching and thermal oxidation is presented. Using this method, a silicon layer is left at the side of waveguide. The stress distribution and effe
期刊
以国产大型客机机身壁板铝合金T型接头双侧激光同步焊接技术的开发为背景,系统地研究了焊接工艺参数与光束姿态对焊缝成形质量的影响,初步探讨了接头的微观组织特征。试验结果表明:采用双侧激光同步焊接方法可以实现机身壁板T型接头的焊接,获得了成形质量良好的接头。激光功率和焊接速度的匹配应使热输入控制在25~35 J/mm之间,同时应匹配合理的送丝速度以保证焊缝表面平滑过渡;在满足熔深及熔合面积要求的前提下,应采用较小的光束入射角度以降低热输入对蒙皮背部的热影响;当光束入射位置偏移桁条0.2 mm左右时,焊缝角度为4