【摘 要】
：
In order to improve the in-flight characteristics of the atomizing droplets during high velocity wire arc spraying (HVAS), some changes have been operated on th
【机 构】
：
National Key Laboratory for Remanufacturing
论文部分内容阅读
In order to improve the in-flight characteristics of the atomizing droplets during high velocity wire arc spraying (HVAS), some changes have been operated on the original design of the HVAS gun configuration. A comparative study was carried out to investigate the microstructure and properties of the coatings produced by the original design spraying gun and the modified one, using 3Cr13 wires of 3 mm in diameter. The characteristics of their jets were examined during spraying. The results indicate that, the included angle between the two wires and the distance from the nozzle to the meeting point of the two vires may have a strong influence on the characteristics of the in-flight droplets and then the coatings. The jet divergence is found to be lower than that of the original one (about 12° against 25°). By modified gun, the adhesion strength, the microhardness and porosity of the coating deposited by modified gun are increased by 39% and 9% respectively. And the porosity of the coatings is decreased by 57%.
其他文献
通过二次正交旋转回归设计,探讨不同种生物菌肥对草莓的产量的影响.以这4种菌肥为决策变量,以草莓产量为目标函数,通过在乌兰察布地区日光温室作物草莓的试验地进行田间试验
UHVCVD-grown Si/Si1- xGex/Si heterostructure was investigated by Photoreflectance spectroscopy (PR). The principle of PR used in semiconductor film was thorough
The ZrO2-CeO2-Al2O3 system has been assessed with the CALPHAD (Calculation of Phase Diagrams) technique using the PARROT procedure. The experimental information
Semi-solid AZ91D magnesium alloy was investigated in isothermal steady-state condition. The influence of stirring technological parameters such as stirring temp
The hydration and pore structure of sulphoaluminate MDF cement were studied by X-ray diffractometer ( XRD ), scanning electron microscope (SEM) and mercury intr
Glass forming ability (GFA) and structural characterization of a new amorphous Al-Ni-Sr alloy melt spun were investigated on the theory of the factors for the g
The low temperature ion sulphuration-an effective surface engineering technique for reducing friction and wear of rubbing-pairs was introduced. It involves the
CO2 laser quick assembly technology is adopted on the surface of cast aluminum ZL104 to form a dense ceramic coating containing a great deal of nanometer Al2O3/
Low-Co AB5-type Mm(NiCoMnA1)5Bx (x = 0, 0.1, 0.2 ) electrode alloys were prepared by casting and rapid quenching.The effects of the rapid quenching on the latti
A new concept of salt core, a melting temperature of which is lower than the solidus temperature of cast alloy,was introduced to produce an integrated casting p