我厂以前钢球毛坯的生产是在轧制成型后,于40吨压力机上逐个会环带(13/16″以上的钢球毛坯),再经过锉削去掉两极点,生产效率低,毛坯质量差,机床噪音大,劳动条件较差。现在制成卧式精整机,其上装有二块整型板,一块是转动的,一块带有缺口是固定的。在两板的工作面上车成互相对应的圆弧形孔型沟道。钢球毛坯进入沟道后,在转动板的带动下向前滚动。由于沟道内外侧的线速度不同,因此钢球表面上任一 Previously, the production of steel ball blanks in our factory was carried out after rolling and forming, one by one on the 40-ton press will ring (13/16 "above the ball blank), and then after filing to remove the poles, the production efficiency is low, the quality of the blank Poor, machine noise, poor working conditions now made of horizontal finishing machine, which is equipped with two plastic plates, one is rotating, one with a fixed gap in the work of the two panels on the car Into the corresponding arc-shaped hole-shaped channel.Wall ball into the trench, driven by the rotating plate to scroll forward.Because the channel inside and outside the line speed is different, so any one of the surface of the ball