【摘 要】
：
The feasibility of forming pollution-free and environmentally benign Ce-based rare earth conversion coatings (short for RECCs) on AZ91 magnesium alloy to enhanc
【机 构】
：
School of Materials Science and Engineering,Greater China Regional Technology Center,Department of A
论文部分内容阅读
The feasibility of forming pollution-free and environmentally benign Ce-based rare earth conversion coatings (short for RECCs) on AZ91 magnesium alloy to enhance corrosion resistance was studied. The effect of optimum processing parameters on corrosion resistance of RECCs, such as density of treating solution, temperature and time of coating formation were discussed. Protective performance of conversion coatings on magnesium alloy was evaluated by moisture/heating test, anodic polarization, etc. The results show that Ce-based RECCs under moisture/heating condition can remain intact, with high coverage and no obvious corrosion phenomenon. Corrosion potential increases and passive phenomenon occurs while current density decreases, therefore Ce-based RECCs can improve corrosion resistance of AZ91 magnesium alloy. The morphology of Ce-based RECCs prepared under optimum process through SEM observation is found to be a few particles coherent to the base coating, and the coating has no cracks and exhibits apparent corrosion resistance during corrosion courses of AZ91 magnesium alloy.
其他文献
In this study we conducted single V-groove butt welding (GTAW) on three types of heat treatable aluminum alloys 2024-T351, 6061-T6 and 7075-T6 and compared the
Carbon nanofiber (CNF)-reinforced polypropylene (CNF/PP) composites with different CNF contents were prepared by melt mixing, and the mechanical properties and
在我国较为落后的品牌竞争意识下,不可避免地形成竞争误区,为此有四方面的对策:一是将品牌策略融入企业战略中;二是注重以质取胜;三是开展多种营销方式;四是建立良好的客户关
TC4 titanium alloy was welded by double-sided gas tungsten arc welding(GTAW) process in comparison with conventional GTAW process, the microstructure and mechan
Gold nanoparticles dispersed Y2O3 films were prepared through a sol-gel method by using yttrium acetate and Au nanoparticles colloid as precursors. The films we
A continuous loading push-out test technique was used to measure the interfacial shear strength of SiC fiber reinforced Ti matrix composites. The interracial sh
An ever increasing demand for zinc has resulted in worldwide efforts to exploit complex and lean grade reserves of zinc oxide ore. In this study experiments wer
Er3+:Y0.5Gd0.5VO4 crystal with good optical quality was grown by Czochraski method. The structure of the crystal was determined by X-ray powder diffraction meth
A numerical model Alloy/M has been applied to investigate the microsegregation in Al-4.45 wt pct Cu alloy. The calculated data were compared with the experiment
The measurements of temperature dependence of the magnetic susceptibility of La1-xSrxCoO3 perovskite oxides at different Sr doping (0≤x≤0.5) and annealing tem