论文部分内容阅读
作者成功地设计了一种使用简便,造价低廉适用于发展中国家城市和农村居民区附近的露天粪坑和沟渠的诱蚊器。用两只圆锥形的塑料电灯罩和纱布做成直径为17cm的笼体。下灯罩的最高处距上灯罩15cm,两灯罩之间用两根长25cm的柚木支撑,以螺丝固定。在上灯罩的顶端装一扇活门,以便将捕获的蚊子取出。麻醉蚊虫时从活门插入一根橡皮管,充入CO_2。在上灯罩的顶端装一根铁丝作为把手。在下灯罩的顶端口上套一只孔径为1cm 的塑料圆锥体,除下灯罩外,两只灯罩之间和支架都用纱布包绕,做成一只蚊笼。在下灯罩的底部安
The author succeeded in designing a mosquito device that is easy to use and low cost and suitable for use in open pit ditches and ditches near urban and rural residential areas in developing countries. A cage of 17 cm in diameter was made of two conical plastic lamp covers and gauze. The highest point of the lower lampshade is 15cm above the upper lampshade, with two 25cm long teak supports between the two lampshades, fixed with screws. A shutter is attached to the top of the upper housing to remove the captured mosquitoes. Narcotic mosquitoes from the valve into a rubber tube filled with CO_2. In the top of the lamp cover with a wire as a handle. A plastic cone with a hole diameter of 1cm was placed on the top port of the lower lampshade. Except for the lampshade, the two lampshades and the bracket were wrapped with gauze to form a mosquito cage. At the bottom of the lower shade safety