风积沙路基干压实技术研究

来源 :华中科技大学学报(城市科学版) | 被引量 : 0次 | 上传用户:epslon003
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
我国是沙漠分布最广泛的国家之一,沙漠地区降水量小、蒸发量大、干燥缺水的气候特点,给沙漠公路路基施工带来了极大不便。本文以新疆塔里木典型沙漠地区风积沙为样品,通过对风积沙颗粒组成、天然含水量分析以及对风积沙样品击实特性的试验研究,提出了沙漠公路路基的干压实技术,以解决沙漠地区筑路用水问题,从而在保证施工质量的前提下缩短工期并降低造价。通过对试验路段的调查和检测,其技术指标均满足设计要求,证实了本文研究成果的可靠性和适用性。实用结果还表明:该技术推广应用于风积沙地区的道路修筑,不仅能稳定路基、增强路面强度,同时对充分利用当地资源、保护生态环境、加快道路建设具有特别重要的经济价值和社会意义。 China is one of the countries with the most desert distribution. The climate characteristics of small precipitation, large evaporation and dryness and water shortage in the desert area have brought great inconvenience to the construction of the highway. Based on the analysis of the aeolian sand particles, the analysis of the natural water content and the compaction characteristics of the aeolian sand samples, the authors put forward the dry compaction technology of the desert highway subgrade. Solve the problem of road water use in the desert area, so as to shorten the construction period and reduce the cost under the premise of ensuring the construction quality. Through the investigation and testing of the test road sections, the technical indexes of the test sections meet the design requirements, which proves the reliability and applicability of the research results in this paper. The practical results also show that the technology can be applied to the road construction in the windy sand area, which not only stabilizes the roadbed and strengthens the road surface strength, but also has special economic value and social significance for making full use of local resources, protecting the ecological environment and accelerating road construction .
其他文献
通过试验表明,干切削奥氏体不锈钢1Cr18Ni9Ti,切削速度在0.33 m/s左右,摩擦系数μ最大,积屑瘤最高,切屑变形系数_l和切削力F_z最小,且与切削速度量驼峰性规律变化;随走刀量增
这里介绍的可变延时开关电路,是人工按动一微动开关时,电源接通对电路供电,待一定的时间(可设定),电源自动被切断,对电路停止供电。要实现上述功能,可用智能器件完成,也可用
提出了一个应变硅沟道电子迁移率解析模型.模型以应变张量为对象研究应变硅沟道电子迁移率,因此与工艺相独立;适用于施加双轴应力及〈100〉/〈110〉方向单轴应力,沟道方向为
在室温下,对聚乙炔的一种单取代衍生物的荧光特性进行了研究.这种聚乙炔的单取代衍生物的薄膜能够发出强的绿色荧光。其荧光光谱的主要荧光峰位于510 nm,而它的两个次要荧光
2014年11月9日,国家主席习近平出席亚太经合组织工商领导人峰会开幕式并发表题为《谋求持久发展共筑亚太梦想》的主旨演讲。习近平强调,当前中国经济呈现出新常态,将给中国带
财务分析的基本依据是财务报表,而财务报表是企业财务报告的核心,是反映企业一定时点的财务状况和一定时期的经营成果、资金变动情况的书面文件,它包括资产负债表、利润及利
在阳极化过程中,藉脉冲调制,可使铝的阳极化膜的性能得到改善。从高电压调制到较之为低的低电压(如从22伏降到15伏)可以增加氧化膜的耐腐蚀性和耐磨损性,并能改善膜层的厚度
本文通过透射电镜、扫描电镜、电子探针和X射线衍射分析,证明了钢在滑动摩擦过程中,摩擦表面所产生的“白层”是一种特殊的马氏体和少量的奥氏体混合组织,其厚度可达25-50μm
本文采用现场浸棒法与实验室中频感应炉浸棒法对Al和Si含量不同的Al_2O_3-C材料以及ZrO_2-C材料进行了抗保护渣侵蚀试验。结果表明,Al和Si的加入量之比为1时,Al_2O_3-C材料抗
一、案例分析 案例一:据天津市统计局抽样调查,1988年天津城市居民人均生活费收入为1231.80元,其中20%低收入户为796.80元,20%高收入户为1854.48元。高低收入户差距从1985年的