Filament diameter measurement system based on dual diffraction

来源 :ChineseOpticsLetters | 被引量 : 0次 | 上传用户:lowsong1
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
This Letter proposes a brand-new filament diameter measurement method based on what is called “dual diffraction,” in that a grating is added behind the filament to make full use of its subdivision and amplification characteristics. Higher measurement accuracy is achieved by this method compared with the traditional diffraction method. To verify its accuracy, three standard filaments with nominal values of 100.2, 120.1, and 140.8 μm are measured by the dual diffraction method and traditional diffraction method under the same experimental conditions. The relative measurement errors of the new method are less than 0.75%, and its average relative error is reduced by 56% compared with the traditional diffraction method.
其他文献
本文从不同改进的掺Rh6G聚甲基丙烯酸甲脂(PMMA)固溶态物质获得了有效的激光.热稳定性得到改善以及工作寿命得到延长.研究了它们的激射和光谱特性.
We analyze the properties of a dual-beamtrap of orthogonally intersecting beams in the geometrical optics regime. We derive analytical expressions for the trapping location and stability criteria for trapping a microparticle with uncollimated Gaussian bea
针对轨枕挡肩裂纹图像精细化分类问题,提出了改进双线性卷积神经网络(B-CNN)模型。该模型先通过全局平均池化链接图像特征中的全局信息以捕捉细微裂纹宽度特征;再通过不同层次特征融合增强特征表达能力,获得有效宽度特征以实现细粒度分类。实验结果表明:该模型与B-CNN模型相比,分类准确率提升了2个百分点,在假阴性率方面,正常类别降低了2.3个百分点,明显裂纹类别降低了4.55个百分点;与基线VGG-D(
在柯林斯(C. B. Collins)的指导下,得克萨斯大学人员用一个APEX电子束源来激励七个大气压的氮和氦的混合气体。采用这种电子束源,他们获得的4278埃处的输出为0.27焦耳/立升,总效率为1.9%。脉宽一般为15毫微秒,峰值输出功率为18兆瓦/立升。
期刊
A diode-pumped master oscillator power amplifier system based on a cryogenic Yb:YAG active-mirror laser has been developed. The performances of the laser amplifier at low temperature and room temperature have been investigated theoretically and experiment
期刊
期刊
Near-infrared fluorescence (NIRF) imaging involves the separation of weak fluorescence signals from backscattered excitation light. The measurement sensitivity of current NIRF imaging systems is limited by the excitation light leakage through rejection fi
We present a network-level signaling mechanism for user access and service setup in light emitting diode (LED)-based visible light communication (VLC) networks and define the corresponding signaling messages. In this mechanism, lamp selection is an import
通过数值模拟对叉指背接触(IBC)晶硅太阳电池的结构参数进行了系统研究, 详细分析了硅片厚度, 电池背面发射区、隔离区、背表面场的面积比以及发射区金属接触线的分布和线宽对电池开路电压、短路电流密度、填充因子和电池转换效率的影响。结果表明:增大发射区面积占比、减小金属接触线的线宽均有利于提高电池转换效率;当电池硅片厚度为220 μm, 背面发射区、隔离区和背表面场的面积比为8∶1∶1, 且发射区的2个金属接触线总线宽为10 μm时, IBC电池的光电转换效率最优值为24.19%。