论文部分内容阅读
一、在安装车载电话时,为了避免车厢内拥挤,最好将车载电话的收发信号主机安装在汽车的后仓车厢内,控制单元装在车厢中间,主机和控制单元连线尽量安装在汽车车门底板的暗道内。二、安装车载电话时,必须先检查电源电压。蓄电瓶电压一般为12V,但要注意,有一种老牌美式吉普车电压是24V,如忽略这一点,会烧毁主机。
First, when installing the car phone, in order to avoid the car crowded, it is best to send and receive signal host phone installed in the car’s rear compartment, the control unit installed in the middle compartment, the host and control unit connection as far as possible installed in the car door Under the floor tunnel. Second, install the car phone, you must first check the power supply voltage. Battery voltage is generally 12V, but beware, there is a veteran American jeep voltage is 24V, if ignored, will destroy the host.