技术手法意大利学派的制琴师先从制作侧板开始。用非常干的木料切成约13mm 厚的形状;琴角内的空洞眼、上围园和下围园处放几小块木头,最常用赤杨木,轻轻粘胶;这就成了后来的琴角和连结侧板各段的上端木和下端木。然后取制作侧板内型的模子顺着模子加工出四个琴角和上、下围园的弧形和高度。 Technical approach The Italian school of luthiers began by making side panels. With very dry wood cut into the shape of about 13mm thick; piano hole inside the eye, on the Wai and the next to put a few small pieces of wood around the park, the most commonly used alder, gently glue; This became later The angle of the piano and the upper and lower ends of the sections that connect the side panels. Then take the mold making the side panels along the mold processing four piano corner and the upper and lower enclosure arc and height.