【摘 要】
：
Based on the feasibility of isothermal superplastic solid state bonding of 40Cr and Cr12MoV steels, the surfaces of both steels to be bonded were ultra-fined th
【机 构】
：
School of Materials Science and Engineering,Henan Key Laboratory of Advanced Non-Ferrous Metals
论文部分内容阅读
Based on the feasibility of isothermal superplastic solid state bonding of 40Cr and Cr12MoV steels, the surfaces of both steels to be bonded were ultra-fined through high frequency hardening, then the superplastic solid state bonding were conducted, the microstructure and fracture surface of bonded joint were observed and analysed, and bonding mechanisms was researched. The experimental results show that with the sample surfaces of 40Cr and Cr12MoV steels after the high frequency hardening, under the prepressing stress of 56.6 MPa, initial strain rate of 1.5×10~(-2) min~(-1) and at the bonding temperature of 800-820℃, the superplastic solid state bonding can be carried out in about 3.5min, and the joint strength is up to that of 40Cr steel base metal and the radial expansion ratio of the joint does not exceed 6%. The superplastic solid state bonding parameter of both steels is within the ranges of the isothermal compressive superplastic deformation of Cr12MoV steel, and the deformation in Cr12MoV steel side near the interfacial zone of joint presents the characteristic of superplasticity. In bonding process, the atoms in two sides of joint interface have diffused each other.
其他文献
From the theoretical point of view,the states of manufacturing resources can be monitored and assessed through the amount of information needed to describe thei
Tracking tests for different polymer materials were carried out to investigate the chaotic behavior of surface discharge.The discharge sequences measured during
In this study, the sol-gel method was introduced to prepare the composite phase change material (CPCM). The CPCM was added to fabric with coating techniques and
Biofuels are liquid or gaseous fuels that are predominantly produced from biomass for transport sector applications.As biofuels are renewable,sustainable,carbon
建设工程质量管理是项目建设中的重中之重，关系到企业的生存之道。本文从质量管理的各个细节入手，详细分析了质量管理的技术措施和管理方法。
A Fricke-PVA-xylenol orange (FPX) hydrogel dosimeter, in good transparency, was prepared by physical crosslinking for three-dimensional dose measurements. The p
本文以铁门代水库除险加固工程中应用虹吸式放水涵管为例，对施工中重点作出了分析，希望能为同类工程坝下涵管改造提供成功的经验。
针对多部件系统固定维修时间长的特点,提出采用机会维修策略,将预防性维修和故障维修有机结合起来,从而分摊系统的固定维修时间,实现提高系统可用度的目的.为此,分析了系统的
The molecular structures, electron affinities, vibrational frequencies and IR intensities of the SF5OX/SF5OX- (X=F, Cl, Br) species have been determined by four
Six N-alkyl-4′-methyl-1,1′-biphenyl-2-sulfonamides were synthesized facilely and efficiently from low cost and readily available benzenesulfonyl chloride and