Characterization of refractory behaviour of complex gold/silver ore by diagnostic leaching

来源 :Transactions of Nonferrous Metals Society of China | 被引量 : 0次 | 上传用户:tedloo
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
The amenability of a refractory ore to the extraction of gold and silver by cyanide leaching was investigated. Diagnostic leaching tests were also performed to shed light on the refractory characteristics of ore. The leaching tests show that the extraction of gold and silver is consistently low, i.e. ≤47% and ≤19.2%, respectively, over a leaching period of 24 h. Even fine grinding (e.g. <38 μm) does not improve the recovery of gold and silver. Diagnostic leaching approach provides information into the cause of the refractoriness of the ore. The findings suggest that the refractoriness is induced by the dissemination and encapsulation of the very fine gold and silver particles largely in the carbonates, oxides and sulfides and, to a small extent, with silicates present in the ore matrix. These findings highlight the practical importance of diagnostic leaching for the understanding of the refractory characteristic of such an ore and for the identification of possible pretreatment options to overcome its refractoriness prior to cyanide leaching. The amenability of a refractory ore to the extraction of gold and silver by cyanide leaching was investigated. Diagnostic leaching tests were also performed to shed light on the refractory characteristics of ore. The leaching tests show that the extraction of gold and silver is consistently low, ie ≤ 47% and ≤ 19.2%, respectively, over a leaching period of 24 h. Even fine grinding (eg <38 μm) does not improve the recovery of gold and silver. Diagnostic leaching trails provides information into the cause of the refractoriness of the ore. The findings suggest that the refractoriness is induced by the dissemination and encapsulation of the very fine gold and silver particles largely in the carbonates, oxides and sulfides and, to a small extent, with silicates present in the ore matrix. the practical importance of diagnostic leaching for the understanding of the refractory characteristic of such an ore and for the identification of possible pretreatment op tions to overcome its refractoriness prior to cyanide leaching.
其他文献
Corrosion studies of a commercially pure titanium in phosphoric acid solutions at 250 ℃ were carried out by immersion test in an autoclave. At lower phosphoric
Surface-treated MmNi3.55Co0.75Mn0.4Al0.3 alloy as negative electrode material of nickel-metal hydride battery was employed to improve the high-rate dischargeabi
Dynamic friction polishing (DFP) is one of the most promising methods appropriate for polishing CVD diamond film with high efficiency and low cost.By this metho
Olivine-structured pure LiFePO4 and doped Li(M, Fe)PO4 (M=La, Ce, Nd, Mn, Co, Ni) have been synthesized by a solvothermal method.X-ray diffraction and field emi
Environmental availability and profile characteristics of arsenic (As), cadmium (Cd), lead (Pb) and zinc (Zn) were studied in contaminated vegetable soils from
High undercooling up to 392 K was achieved in eutectic Ni70.2Si29.8 alloy melt by using glass fluxing combined with cyclic superheating.A small quantity of amor
Hydrided Mg-3Ni-2MnO2 composite powders were fabricated by reactive ball milling with hydrogen, and accumulative hydrogenation kinetics and temperature field of
Laves phase NbCr2 alloys with a composition of Nb-66.7Cr (molar fraction, %) were prepared by mechanical alloying and hot pressing. The microstructures and prop
Epitaxial YBCO superconducting films were deposited on the single crystal LaAlO3. (001) substrate by metal organic deposition method. All YBCO films were fired
The phosphor BaB8O13:Eu3+ were synthesized by solid-state reaction, and their luminescent properties were studied under 254 and 147 nm excitation. The excitatio