汽车制动性能检测技术的实践与探讨

来源 :农业工程 | 被引量 : 0次 | 上传用户:canyang419
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
汽车制动性能是汽车的主要性能指标之一。通过对各种汽车及农用车等低速载货汽车制动性能检测的实践,提出检测过程中应注意的问题,从而确保检测车辆制动性能参数的可靠性,保障行驶车辆交通安全。 Automotive braking performance is one of the main performance indicators of the car. Through the practice of testing the braking performance of low-speed truck with various kinds of vehicles and agricultural vehicles, some problems that should be paid attention to in the testing process are put forward so as to ensure the reliability of testing the braking performance parameters of the vehicle and ensure the traffic safety of the traveling vehicle.
其他文献
本文结合起来作者多年工作经验,针对房屋建筑施工加固的几点,进行了简要的分析,以供参考.
本文通过对荣华二采区10
用正丁胺作为碳源,采用射频辉光放电制备碳膜,选用激光染料R6G和聚乙二醇混合液作为蒸气源,采用单源热蒸发,在蒸发室与染料同时沉积得到混合膜,用拉曼光谱和红外光谱分析了碳
根据奈奎斯特(Nyquist)采样定理,解释了傅利叶变换光谱采集过程中由于折叠而出现的假线现象,并且对假线的特点进行了预测,进而总结出实验过程中利用光学滤波器和电子学滤波器
分别在 673、 873和 1073 K分解 Mg/Al摩尔比为 3的水滑石生成 Mg(Al)O复合物。XRD测定均显示 MgO物相。873K以上焙烧的样品同时存在MgAl_2O_4尖晶石物相。微量吸附量热测定其表面酸碱中心的强度和密度,发现碱中心强度和
At high temperature rise rate, the mechanical properties of 10 # steel were determined experimentally in a very wide range of temperature and strain rates. A ne
A basic solution in series form for the three-phase composite cylindrical model in antiplane piezoelectricity subjected to the action of a singularity in the in
对铸态及电解充氢试样做对比试验后证实,中硅耐热球铁在铸造状态下能固溶一定数量的氢. 氢在石墨/基体界面处明显聚集,降低界面结合能,引发脆性裂纹.拉伸断口亦有明显的氢脆特征.以
gem-Dichlorocyclopropanes were effectively reduced by lithium aluminum hydride, and monocylopropanes were obtained in good yields.
为探究吕家坨井田地质构造格局,根据钻孔勘探资料,采用分形理论和趋势面分析方法,研究了井田7