【摘 要】
：
The energy levels, wave functions and the second-order nonlinear susceptibilities are calculated in GaAs/Al0.2Ga0.8As/Al0.5Ga0.5As asymmetric quantum well (AQW) by using an asymmetric model based on the paraboli
【机 构】
：
InstituteofLaserandOptoelectronics,CollegeofPrecisionInstrumentandOptoelectronicsEngineering,Tianjin
【出 处】
：
OptoelectronicsLetters
论文部分内容阅读
The energy levels, wave functions and the second-order nonlinear susceptibilities are calculated in GaAs/Al0.2Ga0.8As/Al0.5Ga0.5As asymmetric quantum well (AQW) by using an asymmetric model based on the parabolic and non-parabolic band. The influence of non-parabolicity can not be neglected when analyzing the phenomena in narrow quantum wells and in higher lying subband edges in wider wells. The numerical results show that under double resonance (DR) conditions, the secondorder difference frequency generation (DFG) and optical rectification (OR) generation susceptibilities in the AQW reach 2.5019 μm/V and 13.208 μm/V, respectively, which are much larger than those of the bulk GaAs. Besides, we calculate the absorption coefficient of AQW and find out the two pump wavelengths correspond to the maximum absorption, so appropriate pump beams must be selected to generate terahertz (THz) radiation by DFG.
其他文献
In this paper, a novel vertical cavity surface emitting laser (VCSEL) polarization modulation technique based on po-larization switching due to thermal heating in a single transverse mode class 10 G VCSEL at 1 310 nm is demonstrated experimentally. The in
针对组网雷达的干扰效率问题, 设计了一种改进的遗传算法并将其应用于干扰资源分配问题, 进而分别就一对一、多对少、少对多3种分配模型进行了分配方案制定以及干扰效益值计算。通过与其他算法结果的对比, 发现本算法不但取得了较优的分配结果和效益值, 且需要的迭代次数较少, 验证了算法的高效性。
High harmonic generation in gas jets was investigated in different gases up to more than 14 bar backing pressure. The observation of increase of harmonic intensity with increasing pressure and laser intensity shows evidence of the presence of clusters in
本文分析了紫外准分子激光对有机材料的消融过程,用理论模型解释了每个激光脉冲对有机材料的消融量与入射激光能量密度之间的关系.对于有机玻璃.当入射激光能量密度较高时,双光子过程将起主要作用.最后讨论了消融率随有机材料吸收系数之间的关系,对吸收系数较小的材料,消融率随吸收系数改变有一个极大值.
运用等效层理论,设计了一种目标波长分别为780,810,850 nm,在45°入射角下使用的反射镜,该反射镜在保证膜层高反射率的同时实现了对偏振和相位的调控。为了在较宽波段上满足平均反射率高的要求,选用金属银和Ta2O5、SiO2作为光学薄膜的材料。采用电子束蒸发和热蒸发方式并配合石英晶体振荡监控膜厚等工艺,在JGS-1石英基底上获得了500~1600 nm波段范围内平均反射率大于95%,目标波长下消光比分别优于3000∶1、5000∶1和7000∶1的反射镜膜系。所设计的反射镜可以满足空间环境下量子通信
针对单道激光熔覆,利用数值模拟技术得到了激光熔覆过程的温度场;在Q235钢表面制备了Ni基激光熔覆层,基于材料相变理论分析了熔覆层不同深度位置微观组织的形成机理,并研究了添加CeO2、TiO2纳米颗粒对熔覆层组织的影响。结果表明:在激光熔覆过程中,在激光辐照和热传导的共同作用下,熔覆层和基体不同深度区域因温度变化的差异而发生不同类型的相变,从而得到不同的微观组织;在熔覆粉末中添加CeO2、TiO2纳米颗粒,可以通过影响
量子纠缠是实现量子通信和量子计算的重要资源,其中多体纠缠更是构建量子网络实现全局量子计算的基础。本文主要研究如何利用经典的光子回声技术实现光量子态的三体纠缠。在自由空间中向掺杂稀土离子的固态离子系综中射入经典光场,当离子体系达到相位重构条件时即可获得三束存在纠缠的量子光场。基于本方案纠缠产生的技术特点,发现其在提高量子中继器的工作效率上有着潜在的应用价值。
研究了依赖强度耦合Ｊ-Ｃ模型场熵演化的动力学特性，考察了原子相干性对场熵演化的影响。