论文部分内容阅读
通过测定0Cr13Ni8Mo2Al钢与铝合金（LY12）和钛合金（TC4）组成的电偶对的电偶电流的方法,研究了0Cr13Ni8Mo2Al钢在使用中与铝合金和钛合金接触时发生电偶腐蚀的敏感性。研究结果表明:0Cr13Ni8Mo2Al钢与铝合金接触时会产生严重的电偶腐蚀,必须进行防护处理方可使用;与钛合金接触时产生的电偶腐蚀很轻微,可以不进行防护。0Cr13Ni8Mo2Al钢表面进行镀镉钛防护后,与铝合金接触时的电偶电流密度大为减小,相差近10倍;采用环氧锌黄底漆、XM-33-4双组分密封胶防护可以有效地防止0Cr13Ni8Mo2Al钢与铝合金和钛合金接触产生的电偶腐蚀。
By measuring the galvanic current of 0Cr13Ni8Mo2Al steel and aluminum alloy (LY12) and titanium alloy (TC4), the sensitivity of 0Cr13Ni8Mo2Al steel to galvanic corrosion in contact with aluminum alloy and titanium alloy was studied . The results show that: 0Cr13Ni8Mo2Al steel and aluminum alloy contact will have a serious galvanic corrosion, must be protected before use; contact with the titanium alloy galvanic corrosion is very slight, can not be protected. 0Cr13Ni8Mo2Al steel surface after cadmium plated titanium protection, contact with aluminum alloy galvanic current density is greatly reduced, a difference of nearly 10 times; zinc epoxy yellow primer, XM-33-4 two-component sealant protection can Effectively prevent 0Cr13Ni8Mo2Al steel and aluminum alloy and titanium alloy contact galvanic corrosion.