线切割加工薄零件(如样板等),在切割结束时,由于零件的自重,往往将钼丝卡断。这里介绍一种小夹具,可避免断丝。切割快要结束时,用此夹具,如图所示,螺钉固定在不掉落的料上,托住欲掉落部分,这样就不会断丝了。编程时,轮廓线上的起 Wire cutting thin parts (such as templates, etc.), at the end of the cut, due to the weight of the parts, often molybdenum wire stuck. Here to introduce a small fixture, to avoid broken wire. Near the end of cutting, with this fixture, as shown in the figure, the screw is fixed on the material does not fall, drop the part to support the drop, so that will not be broken. When programming, the contour lines up