论文部分内容阅读
Numerical simulation of hydroforming hollow crankshaft
【机 构】
:
SchoolofMaterialsScienceandEngineeringHarbinInstituteofTechnologyHarbin150001China,SchoolofMaterials
【出 处】
:
Transactions of Nonferrous Metals Society of China
【发表日期】
:
2005年S2期
其他文献
Nickel and chromium coatings were produced on the copper sheet using plasma spraying and laser remelting. The sliding wear test was achieved on a block-on-ring
The surface of pure copper alloyed with Ti using double glow discharge process was investigated. The morphology, structure and forming mechanism of the Cu-Ti al
Residual thermal stresses (RTS) of SCS-6 SiC/Ti-24Al-11Nb composite were analyzed by using finite element method (FEM). Three models of fiber array in the compo
<正>AZ31 alloy with minor RE addition was investigated. The material was homogenized, hot-rolled and annealed. Optical microscopy, scanning electron microscopy
Cu-Cr composites were prepared by self-made directional solidification equipment with the high temperature gradient and double-zone heating. The microstructural
The density, cell size and structure of closed-cell aluminum foam were measured by optical microscopy and image analysis. The properties and the mechanism of co
Effects of cooling rate on microstructure and mechanical properties of A357 alloy during differentia
目前农民工劳动现状与体面劳动的要求相差甚远,树立"以人为本"的价值取向是实现农民工体面劳动的关键.具体体现为尊重农民工,突出农民工主体地位;贴近农民工,全面把握农民工的