如图,在牛头刨床上,将虎钳口更换为专用钳口13,螺母10把数个工件6紧固干分度盘轴8上,成为一个装配体,虎钳将这个装配体连同垫板11一并夹紧,调好工件与刀尖的相对位置后,固定工作台,向下送进刀架施行刨切。刨好一槽后,松开虎钳,装配体转一角度(由分度盘上的定位销孔与定位销4的配合实现定位,操作时注意反旋靠住,以提高分度精度),再行 In the shaper, the vise jaws are replaced with special jaws 13, and the nut 10 tightens several of the workpieces 6 onto the dry indexing spindle 8 to form an assembly. The vise holds the assembly together with the backing plate 11 together with the clamp, adjust the relative position of the workpiece and the tip, the fixed table, down into the turret to perform slicing. Placing a good slot, release the vise, the assembly turn a point of view (by the indexing plate on the indexing pin hole and positioning pin 4 to achieve positioning, the operation of the anti-spin to stay in order to improve the accuracy of indexing) Go ahead