【摘 要】
：
Numerical simulation combined with experimental test was carried out to analyze the pre-stretching process of the 7075 aluminum alloy sheet,from which the stres
【机 构】
：
State Key Laboratory of Mechanical Transmission, China Automotive Engineering Research Institute Co.
【基金项目】
：
Technical Special Pilot Program of China;The Fundamental Research Funds for the Central Universities of China
论文部分内容阅读
Numerical simulation combined with experimental test was carried out to analyze the pre-stretching process of the 7075 aluminum alloy sheet,from which the stress variation curves and residual stress of aluminum alloy sheet in different stretch rates were obtained.The results show that the residual stress in length direction is released after unloading the stretch force,while the residual stress in width direction is released during the stretching process.The study of residual stress elimination is beneficial for optimizing stretch rate on the basis of residual stress distribution law.By comparing the variation principle of residual stress in length direction,the size range of three deformation areas and elimination percentage of residual stress were obtained.The residual stresses of clamping area and transition area are not eliminated effectively,so sawing quantity should be the sum of both the areas.The elimination rate of residual stress in even deformation area could reach 90％ after choosing a proper stretch rate,which is verified by both simulation and experiment.
其他文献
The superplastic deformation diffusion bonding of 00Cr25Ni7Mo3N duplex stainless steel was performed on a hot simulator.The microstructure of the bonding interf
Casting-cold extrusion technology was presented to fabricate aluminum/copper clad composite,and copper tubes with different sketch sections were designed.The te
A self-adaptive learning based immune algorithm (SALIA) is proposed to tackle diverse optimization problems,such as complex multi-modal and ill-conditioned prob
The effect of Nb doping on the oxygen permeation and stability of SrCo0.8Fe0.2O3-δ(SCFO)was investigated comprehensively.Cubic perovskite phase was formed in S
The 1∶2 subharmonic resonance of the labyrinth seals-rotor system is investigated,where the low-frequency vibration of steam turbines can be caused by the gas
Effect of element cerium (Ce) on microstructure and mechanical properties of Al-Zn-Mg-Cu alloys has been investigated by transmission electron microscopy (TEM),
The hot dipping process of pure aluminum on H13 steel substrates followed by plasma electrolytic oxidation(PEO)was studied to form alumina ceramic coatings for
The combined effects of (Y,Cu) on the microstructure and room-temperature mechanical properties of the NiAl intermetallic compound under uniaxial compression st
The fact that there are Mn2+ at the A sites in the ABO3 perovskite phase of manganites with the nominal composition La0.6-xNdxSr0.1MnO3 showed by detailed exper
To improve the segmentation quality and efficiency of color image,a novel approach which combines the advantages of the mean shift (MS) segmentation and improve