Modification of Alternative Splicing of Bcl-x Pre-mRNA in Bladder Cancer Cells

来源 :华中科技大学学报(医学英德文版) | 被引量 : 0次 | 上传用户:lkcxm
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
To modify the splicing pattern of Bcl-x and compare the effect of this approach with that of the antisense gene therapy in BIU-87 cell line of bladder cancer, by using 5'-Bcl-x AS to target downstream alternative 5'-Bcl-x splice site to shift splicing from Bcl-xL to Bcl-xS and 3'-Bcl-x AS antisense to the 3'-splice site of exon Ⅲ in Bcl-x pre- mRNA to down regulation of Bcl-xL expression,the inhibitory effects on cancer cells by modification of alternative splicing and antisense gene therapy were observed and compared by microscopy, MTT Assay, RT-PCR, FACS, Westhern bloting and clone formation. The growth of cells BIU-87 was inhibited in a dose- and time-dependent manner. Its inhibitory effect began 12 h after the exposure, reaching a maximum value after 72h. The number of cells decreased in S phase and the number increased in G1 phase. The ability to form foci was reduced and the antisense gene therapy was approximately half as efficient as modification of alternative splicing in inducing apoptosis. It is concluded that modification of splicing pattern of Bcl-x pre-mRNA in bladder cancer cell BIU-87 is better than antisense gene therapy in terms of tumor inhibition.
其他文献
针对通信时延对遥操作系统稳定性和透明性的影响,研究了一种基于双边自适应控制和波变董理论的控制方法.通过设计波控制器保证通信传输模块的无源性,在保证系统稳定的基础上,
研究了Ti(CN)和V(CN)变质剂对铸造Al-Cu-Mn合金微观组织和力学性能的影响.结果表明,当添加量为0.02%时,变质剂Ti(CN)和V(CN)均能有效地细化铸造Al-Cu-Mn合金的基体晶粒并显著
以SU-8作为结构材料,采用紫外光刻工艺,尤其以斜曝光工艺为主,加工出主光轴平行于衬底基片的微透镜阵列,单个微透镜的直径大约为500 μm.初步确定出加工此透镜所需要的曝光剂
Malignant gliomas are the most devastating tumors in clinical practice and have poorest survival. Immunological treatment of such patients may likely increase t
Objective: To observe the effects of conventional therapy combined with Kanlijian (坎离煎,KLJ) on exercise tolerance, quality of life and frequency of heart fai
介绍了给水管网中漏损网络的类型,分析了传统给水管网节点漏损量模型和估算方法的不足,通过GIS空间分析强大功能的特点,提出了一种以GIS与DEM相结合的新的给水管网节点漏损量
为了描述管道除锈机驱动单元的弯管通过性,建立了管道除锈机在弯管处的运动方程与平衡方程,分析了其差速特性与力学特性,得到了驱动单元能够根据环境拓扑约束自主差速,驱动轮
基于ABAQUS软件的Explicit/Standard模块建立了Ni-Cr-W-Mo合金异型件热旋成形的多道次热力耦合三维有限元模型,研究了Ni-Cr-W-Mo合金异型件热旋成形过程中的应力应变场的分布
To investigate effect of the transplantation of mesenchymal stem cells (MSCs) in combination with nerve growth factor (NGF) on the repair of spinal cord injury
To study the relationship of remote sensing normalized differential vegetation index (NDVI) to Anopheles density and malaria incidence rate. Methods Data of mon