国内的数控线切割机,大多数都采用高速走丝单滚筒贮丝机构。在加工过程中若发生断丝,往往造成工件报废,同时由于贮丝筒高速旋转,操作者来不及使它立即停止,断了的钼丝乱缠在贮丝机构上,清理起来十分麻烦。更有甚者废丝若卷进了贮丝筒两端的轴承内,可能损坏轴承,至少影响贮丝筒运转的平稳性。如果能在断丝发生的瞬间,使控制台保持专用 The domestic CNC WEDM, most of them are using high-speed wire single roller storage mechanism. In the process of processing if the broken wire, often resulting in scrapped parts, at the same time as the wire barrel high-speed rotation, the operator too late to stop it immediately, broken molybdenum wire wrapped around the wire storage mechanism, cleaning up is very troublesome. What is more, if the waste silk into the storage tube at both ends of the bearing, may damage the bearings, at least affect the smooth operation of the storage tube. If you can break the moment, make the console dedicated