论文部分内容阅读
1.做好试运转工作试运转是对收割机安装是否正确、调整是否合理、保养是否到位的一个综合检验。在试运转前要按规定给各旋转部位加注黄油、机油和齿轮油。然后用手力拨动整机转动,无异常和杂声后再发动,挂上动力输出档,低速运转半小时左右。此时要观察各部位运转情况,各轴承部位是否发热以及其它方面问题,如果一切正常,便可逐渐提高转速,直至工作到额定数值。经磨合后,应做好有些部位的调整,如
1. To do a good job of commissioning trial operation is the harvester installation is correct, the adjustment is reasonable, maintenance is in place a comprehensive test. Before commissioning according to the provisions of the rotating parts of the filling of butter, oil and gear oil. Then use the hand to dial the whole machine rotation, no abnormalities and noise before starting, hanging power output file, low-speed operation for about half an hour. At this point to observe the operation of various parts of the bearing parts are heating and other aspects of the problem, if everything is normal, you can gradually increase the speed until the work to the rated value. After running in, should make some adjustments, such as