Temperature-dependent optical response of phase-only nematic liquid crystal on silicon devices

来源 :ChineseOpticsLetters | 被引量 : 0次 | 上传用户:xamchendehui
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
Wavelength-dependent birefringence and dielectric anisotropy, two major optical properties of the nematic liquid crystal materials used in phase-only liquid crystal on silicon (LCOS) devices, are measured as a function of operating temperatures. The dynamic phase modulation depth and threshold voltage of these phase-only LCOS devices are also measured in the corresponding temperature range and compared with theoretical predictions. The results show that the dynamic response time can be reduced significantly by an appropriate increase of device operative temperature, while the necessary device elements, such as phase modulation depth and threshold voltage, can be maintained at the same time.
其他文献
从理论上研究了由于五阶极化强度间的干涉所导致的V型三能级系统相位共轭超快调制光谱学, 考虑了抽运光束为窄带线宽或宽带线宽的情形。发现能级分裂的测量精度决定于光学跃迁的均匀增宽, 即这种技术在测量能级分裂时可得到消除多普勒增宽的精度。
In this work, we investigate the methods to improve the performance of the swept source at 1.0 μm based on a polygon scanner, including in-cavity parameters and booster structures out of the cavity. The three in-cavity parameters are the cavity length, th
期刊
期刊
In this paper, we reported a numerical solution of laser induced thermal effect in the bio-tissue. The model of photothermal effect and classical Pennes bio-heat transfer equation were introduced. Finite element method (FEM), which was realized by Matlab
针对数据排列无序、随机缺失及伴随白噪声等问题,提出一种基于因子分析法的三维点云配准方法。将点云数学模型扩展为正交因子模型,从而将点云的配准问题转换为对模型参数的求解问题;采用高斯混合模型对点云进行拟合,并通过最大期望算法(EMA)求解出正交因子模型的因子载荷矩阵;利用因子载荷矩阵完成对点云的配准。在仿真实验中,因子分析算法对随机丢失和带噪声的点云的配准情况,与经典迭代最近点(ICP)算法的配准精度
为了给湍流介质中光学系统的工程设计和性能评估提供参考依据,分析对比了平面波与球面波的光强闪烁。首先,基于经典弱起伏湍流理论推导了孔径接收时光强闪烁的解析表达式。然后,基于扩展的Rytov理论计算非弱起伏条件下的光强闪烁。最后,仿真了不同湍流强度、不同菲涅耳数下平面波与球面波的光强闪烁。结果表明,当Rytov方差小于4.8时,平面波与球面波的光强闪烁曲线存在一个交点,该交点对应菲涅耳数下的平面波闪烁与球面波闪烁强度相等;当Rytov方差大于4.8时,平面波的光强闪烁强度总是小于球面波。该研究对于无线光通信系
美帝卡森公司已制成一种陶瓷等离子管离子激光系统,能用氩、氪或氙作工作物质。每种气体都能得到一组独立的波长。在管内分别充上适当的气体,就能获得兰、绿、黄或红色波段的波长。为了能更广泛地选择颜色,可将气体混合,就能得到很多其它的颜色和白光。这种系统的变形(300型)装置的功率中等,使用氪时,能在红色区得到600毫瓦的输出。使用氩时,这种系统的单模宽带输出为5×3,或1瓦,或100毫瓦,这取决于所利用的系统的型号。如果将这种5瓦的聚焦至比1微米以下的光斑,则能获得500兆瓦的功率密度。
期刊
采用氙灯抽运研究了原子数分数为10%的Er 3 掺杂的YAP晶体在2.7~3 μm波段的激光性能,使用3种不同透射率的输出镜,实现了最大输出能量为1173 mJ@1 Hz、1284 mJ@5 Hz、495 mJ@10 Hz、104 mJ@20 Hz的激光输出,对应的斜率效率分别为0.80%、0.99%、0.84%和0.44%。当重复频率为5 Hz,透射率为15%时,该晶体具有最大的输出能量和激光效率,相应的平均输出功率达到了6.42 W,约是目前已报道最好结果的4
A free-space 1\times2 wavelength-selective switch (WSS) based on thin-film filter technology is proposed. The 1\times2 WSS is fabricated with an electromagnetic actuator, a reflecton prism, a narrow-band thin-film filter, and three fiber collimators. Th