Synthesis of Intermetallic Compounds by Using Lithium Hudride

来源 :稀土学报 | 被引量 : 0次 | 上传用户:guojunaaaa
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
Intermetallic compounds of AB5 type are promising materials for M-H batteries. In this report we present the results about the influence of quality of interme tallic compounds prepared by a new method of synthesis on their electrochemical pr operties. The well-known intermetallic Ln1-xMxNi5-yMe y (Ln=La, Mm; M=Zr; Me=Mn, Ge, Sn, Al, Co+Sn, Co+Ge) compounds were synthe sized by using mixtures of oxides, chlorides and carbonates of metals by intera ction with lithium hydride at 700~1000 ℃. Prepared samples have the uniform mi crostructure with average dimension of particles about 20~30 μm. Electrochemical tests show that kinetic behaviour of compositions are satisfac tory under current up to 200 mA*g-1. These compositions require practical ly no activation and limiting values of the discharge capacity were reached at 2 ~3 cycle up to 300 mAh*g-1, which can be considered as most promising f or practice.
其他文献
The influence of Cu dopant (x) and sintering temperature (Ts) on the transport properties of La2/3 Ca1/3 Mn1- xCuxO3 series samples prepared by Sol-Gel techniqu
Three-layer feedforward networks have been widely used in modeling chemical engineering processes and prior-knowledge-based methods have been introduced to impr
Application of the Semenov theory of spontaneous ignition to evaluation of the critical temperature (Tc′) in thermal explosion (TE) synthesis was conducted wit
By using thermal simulation technique, the conventional canned-forging process of TiAl based alloy was studied. The effect of can parameters on the microstruct
To solve the problems of EDM when using the ordinary fluid and mold manufacturing, this paper provides the orthogonal experiment in the suspended powder fluid,
By using such flier-plate material, quasi-isentropic compression can be realized. Based on it,hypervelocity launching is further accomplished. As a result, an e
The transparent anatase TiO2 nanometer thin films were prepared by the sol-gel method on soda-lime glass. X-ray diffraction, thermal analysis and UV-visible spe
For 308L and 347L weld metals of austenitc stainless steels (ASS), hydrogen induced cracking (HIC) occurred during dynamically charging under constant load. The
A ZA-27 alloy reinforced with M n-containing intermeta llic compounds was prepared and its tribological behaviors were investigated. By adding Mn, RE, Ti and B
The description and transform of three-dimensional decentered Gaussian beam are presented.The characteristic parameters of decentered Gaussian beam after passin