【摘 要】
：
Based on analyzing the traditional process to manufacture fin heat sinks(FHS), the production of FHS by the planing process was proposed, the mechanism of the f
【机 构】
：
College of Mechanical Engineering,School of Mechanical Science and Engineering
论文部分内容阅读
Based on analyzing the traditional process to manufacture fin heat sinks(FHS), the production of FHS by the planing process was proposed, the mechanism of the fins curl was investigated and the fins surface finish was analyzed. Through controlling chip curl based on the continuous strip chips, flat straight fins were processed.Compared with the traditional processes, this process makes full use of material and the processed FHS has better heat transfer capacity, higher heat transfer efficiency and more reliability. The tool geometrical parameters and processing performance affect the fins curl. The optimum processing parameters are: a cutter edge inclination angle of 0°, a rake angle between 50° and 55°, and a planing depth from 0.2 mm to 0.3 mm. The planing speed has little effect on the fins curl.
其他文献
Indium tin oxide ( ITO ) thin films ( 100 ± 10 nm) were deposited on PC ( polycarbonate ) and glass substrates by rf( radio-frequency ) magnetron sputtering. T
The internal frictions of the specimens in the waist centre of the commercial BNb and BNbRE rails, which were left in air for two years, were measured. It is fo
2007年夏季对青岛沿海石莼科绿藻,包括定生石莼Ulva、定生浒苔Enteromorpha以及漂浮浒苔Enteromorpha进行了样本采集,针对其17种金属元素和3种非金属元素进行了含量分析与比
The luminescent nanosized Eu-MCM (1:10) was synthesized by means of sol-gel-assisted self-assembly under basic conditions at room temperature. The results of 29
This paper focused on the folding damage behavior of the space rigidizable materials in terms of 3-layer composite membranes. An experimental scheme was present
Data reconciliation technology can decrease the level of corruption of process data due to measurement noise, but the presence of outliers caused by process pea
Different amounts of dysprosium oxide were incorporated into barium titanate powders synthesized by hydrothermal method. Relations of substitution behaviors and
The influences of the fiber volume fraction on the electrical conductivity and the fraction change of electrical resistance under three-point- bending test were
The PAn-PEO-PAn triblock copolymer with the PEG chain length of 400 was synthesized by chemical oxidation copolymerization of aniline and α, ω- bis ( p- amino
Microwave-assisted extraction (MAE) of isoflavones from Belamcanda chinensis was studied using ethanol as the solvent. The single factor experiment and the orth