【摘 要】
:
Molten salt and supercritical carbon dioxide (S-CO2) are important high temperature heat transfer media,but molten salt/S-CO2 heat exchanger has been seldom rep
【机 构】
:
School of Material Science and Engineering/School of Intelligent Systems, Sun Yat-Sen University, Gu
论文部分内容阅读
Molten salt and supercritical carbon dioxide (S-CO2) are important high temperature heat transfer media,but molten salt/S-CO2 heat exchanger has been seldom reported.In present paper,heat transfer in printed circuit heat exchanger (PCHE) with molten salt and S-CO2 is simulated and analyzed.Since S-CO2 can be drove along passage wall by strong buoyancy force with large density differenee,its heat transfer is enhanced by natural convection.In inlet region,natural convection weakens along flow direction with decreasing Richardson number,and the thermal boundary layer becomes thicker,so local heat transfer coefficient of S-CO2 significantly decreases.In outlet region,turbulent kinetic energy gradually increases,and then heat transfer coefficient increases for turbulent heat transfer enhancement.Compared with transcritical CO2 with lower inlet temperature,local heat transfer coefficient of S-CO2 near inlet is lower for smaller Richardson number,while it will be higher for larger turbulent kinetic energy near outlet.Performance of PCHE is mainly determined by the pressure drop in molten salt passage and the heat transfer resistance in S-CO2 passage.When molten salt passage width increases,molten salt pressure drop significantly decreases,and overall heat transfer coefficient slightly changes,so the comprehensive performance of PCHE is improved.As a result,PCHE unit with three semicircular passages and one semi-elliptic passage has better performance.
其他文献
Gaps in compressors are generally unfavorable because they lead to energy loss.However,gaps on diffuser blades can broaden the operation range of a compressor.T
In order to avoid collision with the end wall of the casing when the guide vane rotates around its own rotating axis in a centrifugal compressor,a circular gap
In this study,mixed convection heat transfer and fluid flow is numerically investigated in an open system enclosure containing a heated obstacle.Effects of the
In this paper,the visualization of the thermo-hydrodynamic behavior in flat-plate pulsating heat pipe(FP-PHP)with HFE-347 is experimentally investigated.The FP-PHP is vertically placed with filling rate of 20%to 70%and heating power of 20 W to 140 W.A hig
The tip leakage flow in different axial gaps is numerically investigated based on the Reynolds-Averaged Navier-Stokes equations and k-ω SST turbulent model usi
In modern high-load high-pressure turbine,the secondary flow in the blade channel is very strong and occupies a large spanwise region.Although high-quality experimental data at the stage interfaces have been obtained in previous research,the influence of
The non-linear temperature glide in the supercritical CO2 cooling process makes the heat transfer pinch point of heat exchanger show multiplicity,like size,loca
The stationary lumped-cell model was developed and used to simulate the thermal characteristics of domestic biomass boiler with helically coiled tube heat excha
In order to determine the sensitivity of influencing factors on NOx emission in gas-fired heating and hot water eombi-boilers,the orthogonal method was adopted
Cooling tower is crucial equipment in the cool-end system of power plant and the natural draft counter-flow wet cooling tower (NDWCT) gets wide application.The