论文部分内容阅读
该机收割台的倾斜输送器,在使用中磨损严重,故障多,而且耙齿和节距为38的滚子链备件不足。根据这种情况,我们把38滚子链改为4英寸平皮带。改装后通过长时间的使用,工作可靠故障少,效果很好。改装方法 1.将原耙齿或用30×30角钢自制的粑齿按原铆在38链子上的距离,交错铆在三条4英寸平皮带上。 2.将主动轴上的三个链轮拆去,在轴上钻两个直径8.5毫米的孔,装上和原主动链轮外圆直径相同尺寸的木制辊(固定木辊的方法与GT—4.9联合收割机
Tilting conveyor of the machine header, in use, serious wear and tear, failure and rake teeth and the pitch of 38 roller chain spare parts are not enough. According to this situation, we change 38 roller chain to 4 inch flat belt. Through the long-term use after modification, reliable work less failure, the effect is very good. Modification method 1. The original rake teeth or with 30 × 30 angle made of the original teeth in the 38 rivets on the distance, staggered rivets in the three 4-inch flat belt. 2. Remove the three sprockets on the drive shaft, drill two holes of 8.5 mm in diameter on the shaft, install the wooden roller of the same size as the outer diameter of the original drive sprocket -4.9 Combine harvester