Dendrite Spacing Selection during Directional Solidification of Pivalic Acid-Ethanol System

来源 :Journal of Materials Science & Technology | 被引量 : 0次 | 上传用户:lucasyvette
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
Unidirectional solidification of pivalic acid(PVA)-ethanol(Eth)mixture was performed to examine whether an allowable range of primary dendrite spacing definitely exists at a given growth velocity and how the range is history-dependent.PVA-0.5g wt pct Eth was unidirectionally solidified in the range of growth velocity 0.5-64μm/s at the temperature gradient of 2.3 K/mm.Sequential change in growth velocity was imposed to determine the upper and lower limits for the allowable range of stable spacing.An allowable range of the steady state primary spacing was observed at a given growth velocity,and the extent of the range seems to be dependent on the degree to which step-increase or step-decrease in growth velocity is accomplished.As the degree of sequential change in growth velocity increases,the history-dependence of the selection for the primary dendrite spacing tends to disappear. Unidirectional solidification of pivalic acid (PVA) -ethanol (Eth) mixture was performed to examine whether an allowable range of primary dendrite spacing exists at a given growth velocity and how the range is history-dependent. PVA-0.5g wt pct Eth was unidirectionally solidified in the range of growth velocity 0.5-64 μm / s at the temperature gradient of 2.3 K / mm. Sequential change in growth velocity was imposed to determine the upper and lower limits for the allowable range of stable spacing. Allowable range of the steady state primary spacing was observed at a given growth velocity, and the extent of the range seems to be dependent on the degree to which step-increase or step-decrease in growth velocity is accomplished. As the degree of sequential change in growth velocity increases , the history-dependence of the selection for the primary dendrite pattern tends to disappear.
其他文献
Y2O3: Er3+, Yb3+ nanoparticles were synthesized by a homogeneous precipitation method without and with different concentrations of EDTA 2Na. Upconversion lumine
The aim of this study is to apply the concept of functionally graded materials (FGMs) to cemented carbides and to develop high-performance rock drill buttons.Co
Creep tests of Mg-5%Zn-2%Al (-2%Y) (mass fraction) alloy were carried out at 175℃ under the load of 50MPa,on the cast and solution condition,respectively.Relat
Water-using operations in the process industry have demands for water usually both on water quality and temperature, and the existing mathematical models of hea
Hydroxyapatite (HA) coating has been prepared on titanium substrate through an electrochemical deposition approach.In order to improve the bonding strength betw
The ab initio self-consistent DV-Xα (discrete variational Xα) method was used in its relativistic and spin-polarized model to investigate the ground-state ele
The solvent selection methodology developed earlier by Gani et al. (Comp. Chem. Eng., 2005) has been extended to handle multi-step reaction systems. The solvent
The directional solidification process of turbine blade sample castings was investigated in the work. Variable withdrawal rates were used in one withdrawal proc
In order to meet the forming demands for low plasticity materials and large height-diameter ratio parts, a new process of hydrodynamic deep drawing (HDD) with i