水平和倾斜管内气液分层流界而稳定性

来源 :中国化学工程学报 | 被引量 : 0次 | 上传用户:a12307856
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
A viscous Kelvin-Helmholtz criterion of the interfacial wave instability is proposed in this paper based on the linear stability analysis of a transient one-dimensional two-fluid model. In this model, the pressure is evaluated using the local momentum balance rather than the hydrostatic approximation. The criterion predicts well the stability limit of stratified flow in horizontal and nearly horizontal pipes. The experimental and theoretical investigation on the effect of pipe inclination on the inteffacial instability are carried out. It is found that the critical liquid height at the onset of interfacial wave instability is insensitive to the pipe inclination. However, the pipe inclination significantly affects critical superficial liquid velocity and wave velocity especially for low gas velocities.
其他文献
随着柔性交流输电系统(flexible AC transmission system,FACTS)的广泛发展,研究其装置容量限制对电压稳定的影响具有重要意义。分析无功补偿设备输出达到容量极限时,可能出
The elements of network profile are proposed. Based on the network traffic distribution model, the network profile includes the application request rate, the br
2006年黄海军教授等深入分析了固定需求的交通网络中用户均衡和系统最优之间的关系;得到用户均衡效率损失上界计算公式.用一种新方法引入一个与均衡流量相关的参数,扩大了已
With the help of plant roots, slope vegetation makes the slope soil mass become a composite material of soil and roots, and thus enhances shear strength of the
To investigate the effect of different disturbances in the upstream, we present numerical simulation of transition for a hypersonic boundary layer on a 5-degree
An improved differential evolution (IDE) algorithm that adopts a novel mutation strategy to speed up the convergence rate is introduced to solve the resource-co
影响高速公路软土地基路基沉降因素很多,各因素对软基沉降的敏感性是不同的.软基影响因素分析对于软基处理设计、施工监控有较大的指导意义.提出采用灰色系统理论中的灰色关
The method of using a narrowband filter to realize matched filtering is derived. A novel method of using spectrum sampling to realize matched filtering is prese
The sticking phenomenon during hot rolling of SUS 430 ferritic stainless steel was investigated by means of a two-disc type high-temperature wear tester. The te