论文部分内容阅读
我厂有些X52、X62立式和卧式铣床由于纵向导轨及传动件润滑部位设计不良,在使用过程中,导轨来油不匀,当拉动手摇泵时,靠近手摇泵一侧的导轨左边及润滑部位的润滑油过多而外溢,导轨右端因得不到油而研损和拉伤。最近,车间师傅将手摇泵主油管移到底座中间,加一个三通管,兵分两路,等量给油(见图),只需拉2~4下,左右两端导轨及各润滑部位便有一层薄薄的油膜,既能合理润滑,又可节约润滑油料。
Some of our factory X52, X62 vertical and horizontal milling machine due to the longitudinal guide rail and transmission parts lubrication parts of the poor design, in the course of use, the rail to uneven oil, when pulling the hand pump, hand pump near the left side of the guide rail And lubricating parts of the excessive oil spill, because the right rail can not get the oil damage and strain. Recently, the workshop master will hand pump main pipe moved to the middle of the base, plus a tee, Bingfen two, the same amount of oil (see photo), just pull 2 to 4, left and right ends of the guide rail and the lubrication The site will have a thin layer of film, both reasonable lubrication, but also save lubricants.