论文部分内容阅读
感应同步器数显装置在安装调试时,常常会出现这种现象,当定尺与滑尺间有相对机械位移时,千分表或数显表调试架显示0.5mm,数显表则显示0.5mm±△x(△x一般为0.001～0.009mm),当继续同向移动时,数显表则显示位移量0.5mm±△x,前后两次显示的位移误差增量刚好为零,一般是以1mm为周期正确计数显示,有时也以0.5mm为周期正确计数显示。通过理论分析和试验发现是由以下几种原因造成的:
Induction Synchronizer digital display device installation and debugging, this phenomenon often occurs, when the length and slide between the relative mechanical displacement, the dial indicator or digital display debugger display 0.5mm, the digital display shows 0.5 mm ± △ x (△ x is generally 0.001 ~ 0.009mm), while continuing to move in the same direction, the digital display shows the displacement of 0.5mm ± △ x, displacement error increments of just before and after the show just zero, usually 1mm cycle for the correct count shows, sometimes with 0.5mm for the correct period count display. Through theoretical analysis and experimental findings are caused by the following reasons: