【机 构】
：
CollegeofChemistry,FuzhouUniversity,Fuzhou350108,ChinaKeyLaboratoryofOptoelectronicMaterialsChemistr
论文部分内容阅读
The behavior of self-polarization emission in lasers has been proved in some cases. However, the degree and direction of polarization were often sensitive and unstable. We experimentally observed different beam profiles versus the angle of the polarizer relative to the polarization direction of the laser. In order to explore the polarization mechanism, the dynamics of intracavity polarized eigenmodes was analyzed theoretically. Simulative results were well consistent with our experimental observations. It indicated that the linear self-polarization emission was a composite state rather than an intrinsic state. This study contributed to the improvement of the polarization stability in passively Q-switched lasers.
其他文献
介绍了结合使用磁光法和Rogowslki线圈法测量快放电脉冲电流,并对KrF准分子体系作了实际测量。
Array size scaling of passive coherent beam combination is explored theoretically. The Strehl ratio variation with wavelength is simulated in 4-, 9-, 16-, and 25-channel fiber arrays. The average Strehl ratio and phase error are calculated. The Strehl rat
在光学线性调频连续波(LFMCW)激光雷达中，受半导体激光器本身性能限制，使用线性电信号调制并不能得到理想的线性调频激光输出，导致激光雷达拍频信号(BFS)频谱的畸变，因此需要对调频非线性响应特性进行研究。分析了半导体激光器调频特性，并且推导出激光雷达调频非线性响应公式。采用离散多项式相位变换(DPT)算法对调频非线性系数进行非线性参数估计和补偿，并搭建实验平台进行验证。实验结果表明采用DPT算法能有效估计激光雷达调频非线性系数，提高了激光雷达测距测速精度。
It is a persistent problem in organic light-emitting diode (OLED) display devices that the efficiency of blue-light source materials is lower than that of green- or red-light source materials. To address this problem, numerous studies have investigated bl
基于空间模式的干涉,tilt-locking技术为稳定激光频率或锁定光学谐振腔提供了一种灵活便捷的方法。在本文中,对tilt-locking技术进行了修改并进行了实验演示。该方法使用非谐振的一阶空间模式TEM01模作为相位参考,并利用TEM01模式和TEM00模式的干涉进行光学腔的锁定。在光学腔的反射光路中添加障碍物以阻挡反射光束的一半。反射光束的通过的一半由单像素光电探测器而不是分离探测器来检测,以导出用于将光学腔的TEM00模式谐振频率锁定到激光频率的误差信号。利用此方法可以将光学腔稳定锁定4 h。
本文介绍用于染料激光调谐的组合式双折射滤光片。给出动态逐片装调方法和激光调谐实验结果。讨论了加工精度对激光调谐实验的影响。
当几年前发现氧化铕（EuO)是铁磁体——在饱和磁场F，原子沿一公共方向排列——时就已预言，EuO薄膜对激光束可选存储器很有价值，因为激光的热会影响材料的磁状态。EuO受到注意的原因在于，它和几种其它的材料一样，既是电绝缘体，又能透过很多种频率的光。
This paper proposes the ‘skin effect’ of the machining-induced damage at high strain rates. The paper first reviews the published research work on machining-induced damage and then identifies the governing factors that dominate damage formation mechanisms
与传统的干涉滤光片相比,背景噪声高是全息滤光片的主要缺点.本文介绍了用倾斜条纹抑制全息滤光片背景噪声的方法,可以收到较好的效果.