论文部分内容阅读
起动发动机时,有些电瓶因桩头卡子过松或接触不良把电瓶桩头烧毁了,致使接线卡子无法固定,从而影响了电瓶的使用寿命。下面介绍一种电瓶自身焊接方法:找一根1号电池的炭棒,去掉铜帽,一头用小刀削尖,然后再用一块长53毫米、宽30毫米、厚0.5毫米的铁皮卷一圆筒,以备焊接时用。焊接时,将电瓶从车上拆下,如果被烧坏的是正极桩头,就把铁筒套到该桩头上,同时把负极的电瓶连接线接好,接
When starting the engine, some of the batteries are burnt out of the pile due to loose or poor contact of the pile head, causing the connection clamp to be unable to be fixed, thus affecting the service life of the battery. The following describes a method of welding their own batteries: Find a No. 1 battery carbon rod, remove the copper cap, a knife sharpened, and then use a 53 mm long, 30 mm wide, 0.5 mm thick steel roll a cylinder , For welding purposes. Welding, the battery removed from the car, if burned is the positive pile head, put the iron sleeve to the pile head, while the negative battery cable connected, then