磁吻合技术在腹腔镜胰十二指肠切除中应用的初步经验

来源 :中华肝胆外科杂志 | 被引量 : 0次 | 上传用户:hoooopy
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
目的:探讨磁吻合技术在腹腔镜胰十二指肠切除术(laparoscopic pancreatoduodenectomy,LPD)中应用的可行性和安全性。方法:回顾分析2018年5月至2019年9月于西安交通大学第一附属医院肝胆外科接受LPD+磁吻合消化道重建的7例患者资料,其中男性6例,女性1例,患者中位年龄63(56~83)岁。观察指标包括磁吻合装置型号、胆肠或胰肠磁吻合操作时间、手术相关参数、术后并发症、磁吻合形成时间及磁体排出时间。结果:7例患者均顺利完成LPD,包括7例胆肠磁吻合和2例胰肠磁吻合,中位手术时间340(310~450)min。胆肠磁吻合环中位直径10(9~12)mm,胆肠磁吻合中位时间11(8~16)min;2例胰肠磁吻合环直径均为5 mm,胰肠磁吻合分别耗时12 min、15 min。4例患者出现并发症,包括A级及B级胰瘘各1例、腹腔感染2例、术后胃排空障碍2例及腹腔出血1例,均予保守治疗好转,磁吻合处均无胆、胰瘘发生。2例胰肠磁吻合口于术后24 d、30 d形成。所有患者体内磁体排出体外中位时间为50(40~170)d,中位随访11(4~18)个月,无胆肠或胰肠吻合口狭窄出现。结论:LPD术中采用磁吻合完成胆肠或胰肠重建安全、有效。“,”Objective:To study our initial experience on feasibility and safety of magnetic compression anastomosis in laparoscopic pancreaticoduodenectomy(LPD).Methods:A retrospective analysis was conducted on the data of 7 patients who underwent LPD with laparoscopic magnetic compression choledochojejunostomy (LMC-CJ) or pancreaticojejunostomy (LMC-PJ) at the Department of Hepatobiliary Surgery, the First Affiliated Hospital of Xi’an Jiaotong University from May 2018 to September 2019. There were 6 males and 1 female. The median age of patients was 63 (56-83) years. Data analyzed included the model of the magnetic anastomosis device, operation time of the LMC-CJ or LMC-PJ, other operation-related parameters, postoperative complications, time to perform magnetic anastomosis, and time of discharge of the magnet from patients’ body.Results:All 7 patients completed LPD successfully, including 7 LMC-CJ and 2 LMC-PJ. The median operation time was 340 (310-450) minutes. The median diameter of the biliary-enteric magnetic anastomosis ring used was 10 (9-12) mm, and the median time of the biliary-enteric magnetic anastomosis was 11 (8-16) min. The diameter of the pancreaticojejunal magnetic anastomosis ring was 5 mm in the two anastomoses, and the times taken were 12 min and 15 min. Complications occurred in 4 patients, including 1 patient each for grade A and grade B pancreatic fistula, 2 patients with abdominal infection, 2 patients with postoperative gastric emptying disorder, and 1 patient with abdominal hemorrhage. All patients responded to conservative treatment. There was no biliary or pancreatic fistula at the magnetic anastomoses. Pancreaticojejunostomy functioned at 24 and 30 days after operation. The median time for the magnets to pass out from the body of all patients was 50 (40-170) days. The median follow-up was 11 (4-18) months. No biliary-enteric or pancreaticojejunostomy stenosis was detected.Conclusion:Magnetic compressive anastomosis was simple, feasible, and safe for choledochojejunostomy or pancreaticojejunostomy in LPD.
其他文献
从董祥的眼里透露出一种智慧和自信的目光。和他在一起,你会感到由衷的踏实和无限的活力。在他的履历表上,有一行字赫然在目:31岁任大同证券董事长兼总经理。也就是说,在当时
研究了表层超快冷工艺下(SUFC) 830MPa级高强精轧螺纹钢筋碳氮化物析出形态、强化方式以及组织特征.结果表明,高强精轧螺纹钢筋析出相有方形、球形和片状三种形态,析出相结构
会议
本文概述我国金刚石产量稳居世界第一,传统金刚石工具取得国际话语权,我国成为超硬材料产业大国惊人发展的成就;并就安泰科技在行业中的引领地位、国际品牌成就作了扼要介绍;
本店店型并不理想,高低错落、柱子非常多,但经营者却因势利导,巧妙地将门店分为医疗器械区、非药品区、非处方药区、处方药区、参茸贵细区、精制饮片区、中药饮片区、顾客休
通过OM,TEM和EBSD等分析手段,并结合热膨胀测试法,研究了Cu对690MPa级HSLA钢焊丝熔敷金属组织转变及组织细化方面的作用,并对其细化机理进行了探讨.研究结果表明,熔敷金属的
会议
采用箱式电阻炉,对9Cr18不锈钢进行不同温度下的淬火加回火处理,并对其组织和力学性能进行观察和检测.结果表明,淬火温度高于1080℃时,晶粒开始长大,材料的强度和硬度随之降
实验室真空感应炉冶炼C-Mn钢,Nb-Ti钢和含Cr钢,轧后采用三段式冷却工艺试制低成本热轧双相钢,分析了成分差异对热轧双相钢组织性能的影响.结果表明,三种成分均可得到铁素体和
本文采用四球试验机考察了含硫极压剂复配和含硫、磷极压剂复配的乳化液的摩擦学性能,并在板带钢轧制过程中的润滑效果进行了研究,同时进行了乳化液破乳实验.结果表明:含硫、
会议
结合阿曼工程150t电炉热装直接还原铁(DRI)工艺设计实践及研究,分析了电炉100%热装DRI对冶炼电耗、电极消耗、冶炼成本及钢水质量等的影响.阐述了热装DRI的工艺流程,设计了热
针对采用传统乳化液润滑的冷轧硅钢板表面出现的白色条纹,即花脸缺陷进行了分析研究,分别使用金相显微镜和扫描电镜对硅钢板的内部组织结构和表面微观形貌进行了观测,并使用