【摘 要】
：
The C/C composite brake discs were prepared by tri-cylindrical chemical vapor deposition (CVD) process. The optimum processing parameters were as follows: depos
【机 构】
：
School of Materials Science and Engineering
论文部分内容阅读
The C/C composite brake discs were prepared by tri-cylindrical chemical vapor deposition (CVD) process. The optimum processing parameters were as follows: deposition temperature was 830-930 ℃, the gas-flow rates of N2 and propylene were 4.8-5.2 m3/h and 5.8-6.2 m3/h, respectively, the furnace pressure was 4.5-5.5 kPa and the deposition time was 200 h.The effects of processing parameters on the densified rates, thermal-physical property and mechanical performance of C/C composite brake discs were studied. The results show that density, heat conductivity, bend strength and abrasion ratio of the multi-cylindrica brake discs are 1.02-1.78 g/cm3, 31 W/(m·K), 114 MPa and 7 μm/s, respectively, which are approximately similar to those of the single-cylindrical ones. The gas flow rate has no relation to the number of the cylinder and furnace loading. The utilization ratio of carbon can be improved by multi-cylinder CVD process without changing the characteristics of brake disc.
其他文献
Strontium titanate synroc samples were synthesized by self-propagating high-temperature synthesis (SHS). Sr directly took part in the synthesis process. As a re
提出基数型群体决策的匿名性、中立性、正响应性、非负响应性、强Pareto原则和局部非独裁性等理性条件,证明了与群体惩罚评分方法相对应的群体惩罚评分映射满足所有这些条
The formulas of the energy gap and superconducting critical temperature appropriate for systems with both odd and even number of electrons are derived; the base
Fractal characters and fractal dimension of time series created by repeller in complicated system were studied and the time series were reconstructed by applyin
This paper deals with some unsteady unidirectional transient flows of Oldroyd-B fluid in an annular pipe. The fractional calculus approach in the constitutive r
It is usually very difficult to directly obtain molecular dissociation energy De and all accurate high-lying vibrational energies for most diatomic electronic s
Ni-based alloy coating on 21-4-N heat-resistant steel was prepared using CO2 laser, and the high-temperature abrasion wear was tested. The microstructure of thi
In order to reduce powder temperature to lower than 100 ℃ in warm compaction by changing polymer lubricant design, powder flowability, warm compacting behavior
Based on the mass balance equations of solute transfer in the radial chromatographic column, the theoretical expression to describe the column efficiency and sh
通过把探索周期轨道的问题转化为一个非负函数的极小化问题,基于空间收缩的思想,反复重新初始化种群以提高群体的差异性,提高对可行域探测的有效性,提出一类精英子空间差异演